Your 2000 Pontiac Grand Amproblems, repair costs and recalls
What we've documented about the 2000 Pontiac Grand Am: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2000 Pontiac Grand Am
12 documented issues apply to 2000, most serious first.
Intake manifold gasket coolant leak
- What you'll notice
- Coolant level keeps dropping with no puddle, a sweet smell, overheating, or milky, tan sludge under the oil cap.
- Why it happens
- The V6 engines use plastic-framed lower intake gaskets that break down with age and the factory coolant. Coolant leaks outside the engine or into the oil. It is the most reported problem on the Grand Am.
- What to do
- Watch the coolant level and temperature gauge. Stop driving if it overheats. Have the gaskets replaced before coolant mixes with the oil and damages the engine bearings.
Head gasket leak, coolant in the oil
- What you'll notice
- Overheating, white exhaust smoke, coolant loss, or a milky look to the oil.
- Why it happens
- The 2.4L Twin Cam is known for head gasket failures, often after an overheat.
- What to do
- Stop driving if it overheats. A cooling system pressure test and combustion leak test will confirm it.
Automatic transmission slipping or failing
- What you'll notice
- Slipping, harsh or delayed shifts, or the car not moving in a gear.
- Why it happens
- The 4-speed automatic wears internally at higher mileage, and owners report failures around 90,000 miles.
- What to do
- Check the fluid. Have codes read before approving a rebuild.
Ignition switch can slip out of Run (recall)
- What you'll notice
- The engine shuts off while driving, often after a bump or with a heavy key ring. Power steering and power brake assist are lost, and airbags may not deploy.
- Why it happens
- The ignition switch can be knocked out of the Run position (recall 14V-400).
- What to do
- Use only the ignition key with nothing else on the ring, and have a dealer complete the recall.
Turn signals and hazard lights can fail (recall)
- What you'll notice
- Turn signals or hazard lights work only sometimes or not at all.
- Why it happens
- Solder joints inside the hazard switch can crack (recall 03V-327).
- What to do
- Check the recall with your VIN. The fix is free.
Rear trailing arm bolt can back out (recall)
- What you'll notice
- A clunk from the left rear, or the car pulling.
- Why it happens
- A bolt holding the rear trailing arm to the knuckle may be under-tightened (recall 00V-116).
- What to do
- Check the recall with your VIN.
Passlock anti-theft no-start
- What you'll notice
- The engine cranks but won't start or starts and dies, and the security light flashes or stays on. Waiting about 10 minutes with the key on sometimes lets it start.
- Why it happens
- The Passlock sensor in the ignition lock cylinder fails or loses its signal, so the anti-theft system cuts fuel.
- What to do
- Try the 10-minute key-on relearn to get home. A shop usually fixes it for good by replacing the lock cylinder sensor or installing a bypass module.
Engine cranks but won't start
- What you'll notice
- The engine turns over normally but won't fire, sometimes only now and then.
- Why it happens
- Owners trace it to several parts: the anti-theft system, a worn ignition switch, the crankshaft or camshaft sensor, or the fuel pump. Many never find a single cause, which makes it the most reported Grand Am complaint.
- What to do
- Note whether the security light is on. Have a shop check for spark, fuel pressure and stored codes while it is acting up rather than swapping parts.
Key won't turn or ignition switch wears out
- What you'll notice
- The key gets hard to turn or won't turn, or the car won't crank even though the dash lights come on.
- Why it happens
- The ignition lock cylinder and switch wear out on these cars.
- What to do
- Don't force the key. A worn lock cylinder or switch is usually replaced, and the Passlock relearn is done at the same time.
Window drops into the door
- What you'll notice
- A window falls down into the door or won't go up or down.
- Why it happens
- The power window regulator breaks.
- What to do
- Tape the glass up to keep weather out and have the regulator replaced.
Manual transmission can stay in gear when shifted to Reverse (recall)
- What you'll notice
- On manual cars, shifting from fifth to reverse leaves it in fourth, and the key can come out while in gear.
- Why it happens
- A reverse shift inhibitor fault (recall 00V-372).
- What to do
- Use the parking brake every time you park and check the recall.
Center console lid may open in a crash (recall)
- What you'll notice
- No symptom in daily use.
- Why it happens
- The console cover latch may not hold under load (recall 00V-140).
- What to do
- Check the recall with your VIN.
Repair prices for your 2000 Pontiac Grand Am
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace lower intake manifold gaskets and refill coolant
- Replace ignition lock cylinder / Passlock sensor
- Diagnose no-start and replace sensor or fuel pump
- Replace head gasket and resurface head
- Rebuild or replace automatic transmission
- Replace ignition switch or lock cylinder
- Replace power window regulator
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Install key insert / key ring fixNo charge if your vehicle is included
- Replace hazard switchNo charge if your vehicle is included
- Replace console lid latchNo charge if your vehicle is included
- Replace and torque trailing arm boltNo charge if your vehicle is included
- Repair reverse inhibitorNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…