Your 2015 Ram ProMaster Cityproblems, repair costs and recalls
What we've documented about the 2015 Ram ProMaster City: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2015 Ram ProMaster City
16 documented issues apply to 2015, most serious first.
Nine-speed automatic failure or slipping into neutral
- What you'll notice
- The van drops into neutral while driving, won't pick up a gear after leaving Park, slips, or loses drive altogether. A transmission service message may appear.
- Why it happens
- The early 948TE nine-speed automatic had enough internal and control problems that FCA extended its warranty on 2015 ProMaster City vans to 6 years or 100,000 miles. Owners also report failed valve bodies and range sensors.
- What to do
- If it loses drive, get off the road safely and have it towed. Ask a Ram dealer to check your VIN for warranty extension X80 before paying for a transmission.
Excessive oil consumption on the 2.4L
- What you'll notice
- The oil level drops between changes with no visible leak, and the low oil pressure light may come on. Running low can damage the engine.
- Why it happens
- FCA traced the problem to how the engine computer cut fuel during deceleration. It extended coverage on 2015-2018 ProMaster City vans built through August 8, 2018 to 7 years or 100,000 miles, with an engine long block replacement if the van fails an oil consumption test.
- What to do
- Check the dipstick every fill-up or two and top off as needed. If it uses oil, ask a dealer for the oil consumption test and the XB1 warranty extension.
Cooling fan motor wears out and the engine overheats
- What you'll notice
- A whining or grinding fan noise, a check engine light (often a cooling fan code such as P0481), the temperature gauge climbing in traffic, or overheating that needs a tow.
- Why it happens
- Early fan motors used a bushing that was not lubricated well and wore against its shaft. FCA notice V54 covers 2015-2017 vans and replaces the fan module free if it is the older bushing type.
- What to do
- Stop driving if the gauge climbs into the red. Ask a Ram dealer whether notice V54 applies to your VIN; the fix is free if it does.
Sudden loss of power or limp mode
- What you'll notice
- The engine cuts out or drops to a crawl of about 5-20 mph with warning lights on. Restarting may help for a while before it happens again.
- Why it happens
- Owners report the engine or transmission computer putting the van in a protective limp mode. Causes vary, so the stored trouble codes matter.
- What to do
- Get off the road safely. Have the codes read as soon as possible, before clearing them, so the cause can be found.
Harsh, late or erratic shifts from the nine-speed
- What you'll notice
- Jerky or clunky shifts, especially at low speed, delayed downshifts, hunting between gears, or a shudder when pulling away.
- Why it happens
- The nine-speed automatic depends heavily on its control software and learned shift settings. FCA issued several updates to the transmission computer and a relearn procedure to smooth out shifting.
- What to do
- Ask the dealer to check for transmission software updates and to run the quick learn procedure. Make sure the fluid level is correct before anything else is replaced.
Trailer brake lights don't work (recall)
- What you'll notice
- When towing, the trailer's brake lights don't come on when you press the brake.
- Why it happens
- Software in the trailer tow lighting module could stop the trailer brake lights from working.
- What to do
- If you tow, have a helper check the trailer lights and ask the dealer to replace the trailer light module for free.
Free at a dealer when your VIN is included in the recall.
Parking brake sticks or won't hold in cold weather
- What you'll notice
- The parking brake freezes on and drags, won't release, or doesn't hold the van on a hill. Rear brakes may wear quickly afterward.
- Why it happens
- Owners report the parking brake cable and rear brake parts freezing or binding, especially in winter.
- What to do
- Have the rear brakes and parking brake cables inspected. In freezing weather, use wheel chocks rather than the parking brake if it has been sticking.
Oil leak from the oil filter housing or cooler
- What you'll notice
- Oil spots under the front of the van, a burning oil smell, or the oil level dropping.
- Why it happens
- Owners report leaks from the oil cooler and from the oil filter mounting surface on the 2.4L engine.
- What to do
- Have the leak cleaned and traced with dye before parts are replaced. Keep the oil topped up in the meantime.
Clunk at low speed from worn front axle joints
- What you'll notice
- A clunk when pulling away or turning at low speed, or vibration when accelerating.
- Why it happens
- Worn front half shafts, CV joints or tripod joints. FCA has a service bulletin for this noise, and owners report CV replacements around 80,000 miles.
- What to do
- Have the front axles checked for play and torn boots. Replace a worn axle before the joint fails.
Wrong tire pressure and load label (recall)
- What you'll notice
- The label on the door jamb may list the wrong tire pressure, load capacity, seating count or spare size.
- Why it happens
- The tire placard was printed with incorrect information. Overloading or wrong tire pressure can affect handling.
- What to do
- Ask the dealer for the free replacement label, and use the correct pressure from the dealer until then.
Free at a dealer when your VIN is included in the recall.
Brake squeal or grinding
- What you'll notice
- Squealing, scrubbing or grinding from the front or rear brakes, sometimes soon after new brakes.
- Why it happens
- FCA issued service bulletins for front brake noise (new pads and hardware) and rear brake noise (new shoes and wheel cylinders) on early vans.
- What to do
- Have the brakes inspected. Mention the factory brake noise bulletins so the shop uses the updated parts.
Squeaky or noisy door hinge
- What you'll notice
- A creak or pop when opening or closing a door.
- Why it happens
- A service bulletin covers noisy side door hinges, with replacement only for hinges that have a built-in door check.
- What to do
- Try lubricating the hinge first. If the noise returns, ask a dealer about the hinge bulletin.
Door handle or latch binds or won't open
- What you'll notice
- An outside door handle that does nothing when pulled, or a door latch that sticks.
- Why it happens
- Service information covers front and cargo door latches and outside handles that stop working or bind.
- What to do
- Have the latch and handle checked before the door won't open at all.
Check engine light for small evaporative leak
- What you'll notice
- Check engine light with code P0456 (small evaporative emissions leak). The van drives normally.
- Why it happens
- A small leak in the fuel vapor system, often a gas cap, hose or seal. FCA issued a special test procedure for this code.
- What to do
- Make sure the gas cap clicks tight. If the light returns, have the vapor system smoke tested.
Dash display hard to read or goes dark
- What you'll notice
- The speedometer and gauges are hard to read in daylight even at full brightness, or the gauge display goes black or stops working.
- Why it happens
- Owners report dim cluster lighting on early vans and instrument displays failing on later ones.
- What to do
- Have the instrument cluster checked if gauges stop working; you need a working speedometer. Check the brightness setting first if it's only dim.
Headlight bulbs burn out often
- What you'll notice
- Headlight bulbs fail every few months.
- Why it happens
- Owners report repeated headlight bulb failures. Touching the glass of a new bulb or a poor connection can shorten bulb life.
- What to do
- Replace bulbs in pairs without touching the glass, and have the connector and wiring checked if they keep failing.
Repair prices for your 2015 Ram ProMaster City
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace nine-speed automatic transmission (remanufactured)
- Transmission software update and quick learn
- Oil consumption test, then engine long block if it fails
- Replace engine cooling fan module
- Replace rear brake shoes and parking brake cables
- Replace front brake pads and hardware
- Diagnose limp mode and repair the cause
- Replace oil cooler or filter adapter and seals
- Replace front CV axle
- Lubricate or replace door hinge
- Replace door latch or outside handle
- Smoke test and replace leaking EVAP part
- Repair or replace instrument cluster
- Replace headlight bulbs
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…