Your 2018 Ram ProMaster Cityproblems, repair costs and recalls
What we've documented about the 2018 Ram ProMaster City: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2018 Ram ProMaster City
11 documented issues apply to 2018, most serious first.
Excessive oil consumption on the 2.4L
- What you'll notice
- The oil level drops between changes with no visible leak, and the low oil pressure light may come on. Running low can damage the engine.
- Why it happens
- FCA traced the problem to how the engine computer cut fuel during deceleration. It extended coverage on 2015-2018 ProMaster City vans built through August 8, 2018 to 7 years or 100,000 miles, with an engine long block replacement if the van fails an oil consumption test.
- What to do
- Check the dipstick every fill-up or two and top off as needed. If it uses oil, ask a dealer for the oil consumption test and the XB1 warranty extension.
Power steering rack can crack and leak (recall)
- What you'll notice
- Power steering fluid leaking under the front of the van and steering that suddenly takes much more effort.
- Why it happens
- A casting flaw in the hydraulic steering rack housing could crack and let fluid escape.
- What to do
- Have a dealer check whether recall U23 has been done. The inspection and any rack replacement are free.
Free at a dealer when your VIN is included in the recall.
Cracked cylinder head needing a new engine
- What you'll notice
- Coolant loss, overheating, white exhaust smoke, misfires, or an engine that runs badly or won't run, often around 80,000 miles.
- Why it happens
- Several owners report cracked cylinder heads on the 2.4L engine that led to full engine replacement after the powertrain warranty ended.
- What to do
- If you lose coolant or see the gauge climb, stop and have a cooling system pressure test done before the damage spreads.
Harsh, late or erratic shifts from the nine-speed
- What you'll notice
- Jerky or clunky shifts, especially at low speed, delayed downshifts, hunting between gears, or a shudder when pulling away.
- Why it happens
- The nine-speed automatic depends heavily on its control software and learned shift settings. FCA issued several updates to the transmission computer and a relearn procedure to smooth out shifting.
- What to do
- Ask the dealer to check for transmission software updates and to run the quick learn procedure. Make sure the fluid level is correct before anything else is replaced.
Oil leak from the oil filter housing or cooler
- What you'll notice
- Oil spots under the front of the van, a burning oil smell, or the oil level dropping.
- Why it happens
- Owners report leaks from the oil cooler and from the oil filter mounting surface on the 2.4L engine.
- What to do
- Have the leak cleaned and traced with dye before parts are replaced. Keep the oil topped up in the meantime.
Clunk at low speed from worn front axle joints
- What you'll notice
- A clunk when pulling away or turning at low speed, or vibration when accelerating.
- Why it happens
- Worn front half shafts, CV joints or tripod joints. FCA has a service bulletin for this noise, and owners report CV replacements around 80,000 miles.
- What to do
- Have the front axles checked for play and torn boots. Replace a worn axle before the joint fails.
A/C stops blowing cold
- What you'll notice
- The A/C blows warm air, or cools poorly on hot days.
- Why it happens
- Service cases cover low refrigerant with no obvious leak and a faulty A/C pressure sensor that keeps the compressor from running.
- What to do
- Have the A/C pressures and codes checked and do a proper leak test before replacing major parts.
Wrong tire pressure and load label (recall)
- What you'll notice
- The label on the door jamb may list the wrong tire pressure, load capacity, seating count or spare size.
- Why it happens
- The tire placard was printed with incorrect information. Overloading or wrong tire pressure can affect handling.
- What to do
- Ask the dealer for the free replacement label, and use the correct pressure from the dealer until then.
Free at a dealer when your VIN is included in the recall.
Squeaky or noisy door hinge
- What you'll notice
- A creak or pop when opening or closing a door.
- Why it happens
- A service bulletin covers noisy side door hinges, with replacement only for hinges that have a built-in door check.
- What to do
- Try lubricating the hinge first. If the noise returns, ask a dealer about the hinge bulletin.
Check engine light for small evaporative leak
- What you'll notice
- Check engine light with code P0456 (small evaporative emissions leak). The van drives normally.
- Why it happens
- A small leak in the fuel vapor system, often a gas cap, hose or seal. FCA issued a special test procedure for this code.
- What to do
- Make sure the gas cap clicks tight. If the light returns, have the vapor system smoke tested.
Dash display hard to read or goes dark
- What you'll notice
- The speedometer and gauges are hard to read in daylight even at full brightness, or the gauge display goes black or stops working.
- Why it happens
- Owners report dim cluster lighting on early vans and instrument displays failing on later ones.
- What to do
- Have the instrument cluster checked if gauges stop working; you need a working speedometer. Check the brightness setting first if it's only dim.
Repair prices for your 2018 Ram ProMaster City
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Transmission software update and quick learn
- Oil consumption test, then engine long block if it fails
- Replace oil cooler or filter adapter and seals
- Replace engine with a used or remanufactured 2.4L
- Replace front CV axle
- Lubricate or replace door hinge
- A/C diagnosis, leak test and pressure sensor or recharge
- Smoke test and replace leaking EVAP part
- Repair or replace instrument cluster
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…