Your 2000 Saab 9-3problems, repair costs and recalls
What we've documented about the 2000 Saab 9-3: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2000 Saab 9-3
8 documented issues apply to 2000, most serious first.
Oil sludge and oil starvation
- What you'll notice
- The oil pressure light flickers or comes on, the engine knocks or ticks, or it suddenly loses power. In bad cases the engine seizes with little warning.
- Why it happens
- On the early turbo four-cylinders, long oil-change intervals let sludge and carbon build up and clog the screen on the oil pickup in the pan. Heat from the nearby catalytic converter is thought to cook the oil. The oil light often only comes on once pressure is already gone.
- What to do
- If the oil light comes on, pull over and shut the engine off. On any car from these years, have a shop drop the oil pan and clean the pickup if the history is unknown, then change synthetic oil about every 5,000 miles.
Ignition module can overheat and stall the engine (recall)
- What you'll notice
- The engine misfires, runs rough or stalls while driving and may not restart.
- Why it happens
- A transistor inside the ignition discharge module (the ignition cassette that sits on top of the spark plugs) can overheat and burn out. Saab recalled modules built before a certain production change on these engines.
- What to do
- Have a Saab-knowledgeable shop or GM dealer check the module date code and whether the recall was done. A failing cassette is a common cause of misfires on these engines either way.
Timing chain or balance shaft chain rattle
- What you'll notice
- A rattle or chatter from the front of the engine, often worst on a cold start, sometimes with a check engine light or a new vibration.
- Why it happens
- The timing chain and the separate balance shaft chain wear out faster when the oil is dirty or sludged. Tensioners and plastic guides can break, and a broken guide can damage other parts.
- What to do
- Do not ignore a new rattle. Have the chains, guides and tensioner inspected; a chain that jumps a tooth can cause serious engine damage. Keep oil changes short and on schedule.
Turbocharger oil leak or failure
- What you'll notice
- Blue smoke on start-up, oil use between changes, a whistle or loss of boost, or oil around the turbo pipes.
- Why it happens
- Turbo seals wear, and a blocked oil return line or a leaking oil feed pipe can starve or flood the turbo. Sludged oil speeds this up.
- What to do
- Check the oil level often. Have the turbo, its oil lines and the crankcase ventilation checked before the turbo fails completely.
Steering rack mount cracking the firewall
- What you'll notice
- Creaks from the steering, a loose or vague steering feel.
- Why it happens
- The steering rack bolts to the firewall, which flexes and can crack around the mounting points over time.
- What to do
- Have the rack mounting points inspected. Cracks are repaired by welding or a reinforcing brace.
Water pump leak
- What you'll notice
- Coolant drips under the front of the car, a sweet smell, the low-coolant warning, or the temperature gauge rising.
- Why it happens
- The water pump seal wears out. Owners report leaking pumps on both the 2.0T and 2.8 V6 from about 40,000 to 90,000 miles.
- What to do
- Top up with the correct coolant and have the leak traced. Replace the pump before it overheats the engine.
Broken heater air-direction control shaft
- What you'll notice
- Turning the air-direction knob does nothing, so air won't switch between face, feet and windshield.
- Why it happens
- A plastic telescopic shaft behind the dash breaks after repeated flexing.
- What to do
- The replacement shaft is inexpensive and can be reached from the side of the center console.
Information display (SID) missing pixels
- What you'll notice
- Letters and numbers on the dash information display fade or have missing lines, making messages hard to read.
- Why it happens
- The small LCD screen in the Saab Information Display wears out.
- What to do
- Only the LCD needs replacing, not the whole unit. Saab specialists and DIY kits handle this.
Repair prices for your 2000 Saab 9-3
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Drop oil pan, clean sludge and oil pickup, update crankcase ventilation
- Replace timing or balance shaft chain, guides and tensioner
- Replace turbocharger and oil feed/return lines
- Replace water pump and coolant
- Replace air-direction control shaft
- Repair firewall cracks and fit a steering rack brace
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace ignition discharge moduleNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…