Saturn Vueproblems, repair costs and recalls
Problems reported across 2002–2010. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
25 documented issues across all years, most serious first.
VTi CVT transmission slips or fails
- What you'll notice
- The engine revs but the Vue barely moves, it jerks or shudders, makes whining or grinding noises, or will not go in Drive or Reverse.
- Why it happens
- Four-cylinder Vues with an automatic used GM's VTi continuously variable transmission (CVT), which failed often. GM stretched its warranty to 5 years/75,000 miles and later settled a class action covering 2002-2005 Vues.
- What to do
- Stop driving hard if it slips. Get a transmission diagnosis; failed units are usually replaced. Keep every receipt.
6-speed automatic loses 3rd, 5th and Reverse
- What you'll notice
- The transmission suddenly stops shifting into some gears, will not back up, or drops into a limp mode stuck in one gear.
- Why it happens
- A wave plate inside the 6-speed automatic used with the V6 can crack, which takes out 3rd, 5th and Reverse together. GM offered special coverage on this part for several 2007-2009 models.
- What to do
- Do not keep driving it in limp mode. Have a GM dealer check for the wave plate failure and ask whether any special coverage still applies to your VIN.
V6 5-speed automatic slips or shifts harshly
- What you'll notice
- Slipping, flaring revs between gears, harsh or late shifts, and a check engine light for gear ratio or torque converter codes.
- Why it happens
- The Honda-built 5-speed automatic used with the 3.5L V6 can wear its clutches and torque converter lockup, especially with old fluid.
- What to do
- Check the fluid and have the codes read. A fluid change sometimes helps if done early; slipping that keeps coming back usually means a rebuild or replacement.
Timing chain stretch
- What you'll notice
- Check engine light with cam timing codes such as P0008, P0016 or P0017, a rattle at start-up, and rough running.
- Why it happens
- The timing chains on GM's 3.6L V6 can stretch, especially with long oil-change intervals. GM issued bulletins on timing chain kit and guide replacement for these engines.
- What to do
- Do not ignore the codes. Have the chain stretch confirmed and the chains, guides and tensioners replaced together before a chain jumps.
Timing chain rattle and tensioner failure
- What you'll notice
- A rattle from the engine on cold start or at idle, cam timing codes, rough running, or a no-start in bad cases.
- Why it happens
- The timing chain tensioner and guides on the 2.2L Ecotec wear, and early engines did not oil the tensioner well at idle. Low oil makes it worse.
- What to do
- Keep the oil full. If the rattle persists, have the chain, guides and tensioner replaced before the chain skips and damages valves.
Electric power steering loses assist or feels jerky
- What you'll notice
- Steering suddenly gets heavy, or the assist lags and then over-corrects, sometimes with dash lights flickering.
- Why it happens
- First-generation Vues use electric power steering. Failures of the steering motor, its sensor or the body control module that feeds it cause loss of assist.
- What to do
- You can still steer, but slow down. Have the steering codes read; the steering column motor assembly or the control module is usually replaced.
Power steering cuts out or binds
- What you'll notice
- Steering goes heavy without warning, shakes, or feels like it locks up, sometimes at highway speed. A restart may bring it back.
- Why it happens
- Owners report failed power steering pumps and steering racks on the second-generation Vue.
- What to do
- Pull over safely if steering binds. Have the pump, rack and fluid checked; replacing the failed pump or rack is the usual fix.
Power steering line can leak onto exhaust (recall)
- What you'll notice
- Power steering fluid drips, a burning smell, or smoke from under the hood.
- Why it happens
- A fitting nut on a power steering line could leak fluid onto hot exhaust parts and start a fire. GM recall 08V-470 fixes the line.
- What to do
- If you see smoke or smell burning fluid, stop and shut off the engine. Check your VIN for open recall 08V-470.
Key can come out when not in Off (recall)
- What you'll notice
- You can remove the key even though the ignition is not fully in Off.
- Why it happens
- Wear in the ignition lock lets the key come out early, so an automatic might not be locked in Park and could roll away. GM recall 14V-490 fixes it.
- What to do
- Always set the parking brake. Check your VIN for open recall 14V-490.
Engine cuts out while driving
- What you'll notice
- The engine stalls while driving or at stops and may not restart for 5 to 10 minutes.
- Why it happens
- A failing crankshaft position sensor is the most common cause owners find, which typically acts up once the engine is hot.
- What to do
- Have the codes read right after a stall. Replacing the crankshaft sensor is cheap and worth checking first.
Raw fuel smell from cracked fuel pump fittings
- What you'll notice
- A strong gas smell near the right rear of the car, or fuel dripping, often with no warning light.
- Why it happens
- Plastic fittings on top of the fuel pump module and the nylon fuel lines that clip to them can crack and seep fuel.
- What to do
- Do not park it in a garage while it smells of gas. Have the top of the tank inspected; the pump module or lines get replaced.
Outside door handle can keep door from latching (recall)
- What you'll notice
- A door handle sticks out or binds, and the door may not latch fully.
- Why it happens
- The outside door handle could bind, so the door might not stay latched while driving. GM recall 09V-233 fixes the handle.
- What to do
- Make sure every door is fully shut before driving and always wear seat belts. Check your VIN for open recall 09V-233.
Wrong steering knuckle can make a wheel turn out (recall)
- What you'll notice
- No warning before failure; after a tie rod separates, a front wheel can turn out and skid.
- Why it happens
- Some Vues were built with incorrect steering knuckles that could let a tie rod separate under hard braking or bumps. GM recall 08V-616 replaces them.
- What to do
- Check your VIN for open recall 08V-616 before driving far.
Hybrid system shuts down from battery sensor or fan fault
- What you'll notice
- Check engine light with hybrid codes, auto stop-start and power assist stop working, and the car may die after 30 to 60 minutes of driving.
- Why it happens
- The hybrid battery pack is sensitive to heat. Its temperature sensors or cooling fan can fail, and a fault in the belt alternator-starter or its control modules also shuts the hybrid system off. Without it, the car runs only on the 12V battery.
- What to do
- Do not plan long trips with the hybrid warning on, and note that a jump-start will not help. Take it to a GM dealer or hybrid-capable shop to read the hybrid codes.
Hybrid battery pack can leak internally (recall)
- What you'll notice
- Hybrid warning lights or reduced hybrid function; often no symptom before the recall fix.
- Why it happens
- A manufacturing defect caused internal leakage in the hybrid battery on early Green Line Vues, and GM recalled about 9,000 of them.
- What to do
- Ask a GM dealer to check your VIN for any open hybrid battery recall.
4-speed automatic hesitates, slips or fails
- What you'll notice
- A pause before the Vue moves, slipping from Reverse into Drive, getting stuck in one gear, or a fluid leak.
- Why it happens
- Owners of four-cylinder 2008-2009 Vues report wear and internal damage in the 4-speed automatic.
- What to do
- Check the fluid level and condition and have the codes read. Repeated slipping usually needs a rebuild.
Front wheel bearing hum or grinding
- What you'll notice
- A humming, growling or grinding noise that gets louder with speed and may change when turning, sometimes with an ABS light.
- Why it happens
- The front wheel bearing and hub assemblies wear out early on many first-generation Vues.
- What to do
- Have the bearing checked soon; a badly worn bearing can get loose. Replacing the hub assembly fixes it.
All lights flash and electrical glitches at start-up
- What you'll notice
- Every light on the car flashes after starting, the radio cuts out, locks stop working, or steering assist drops, often in cold weather.
- Why it happens
- Shops point to the body control module or main computer; owners report that new batteries and alternators did not fix it.
- What to do
- Have the battery tested first, then ask for a scan of body module codes. Write down when it happens so the shop can repeat it.
Key gets stuck in the ignition
- What you'll notice
- The key will not turn or will not come out of the ignition.
- Why it happens
- A worn ignition lock cylinder or switch is the usual cause.
- What to do
- Do not force the key. A shop or dealer can replace the lock cylinder or ignition switch.
Airbag warning light on
- What you'll notice
- The airbag light stays on, and some owners report airbags that did not deploy or went off unexpectedly.
- Why it happens
- A fault in the frontal airbag sensor or control module, or its wiring, turns on the light and can disable the airbags.
- What to do
- Have the airbag codes read soon, because the airbags may not work while the light is on.
Manual clutch hydraulic leak
- What you'll notice
- The clutch pedal goes soft or to the floor and gears are hard to select, with fluid loss from the clutch reservoir.
- Why it happens
- The clutch master or slave cylinder hydraulic system can leak on manual-transmission Vues.
- What to do
- Check the clutch fluid level. If it keeps dropping, have the clutch hydraulics replaced before the pedal fails completely.
Seat belt anchor bolts may be wrong (recall)
- What you'll notice
- No symptom.
- Why it happens
- On a small group of early Vues the seat belt anchor bolts were installed incorrectly and could fail in a crash. GM recall 01V-386 fixes them.
- What to do
- Check your VIN for open recall 01V-386.
Serpentine belt and tensioner wear quickly
- What you'll notice
- A squeal or chirp at start-up, especially when the engine restarts after an auto stop, or a hybrid warning if the belt slips.
- Why it happens
- The belt drives the motor-generator that restarts the engine and adds power, so it wears faster than a normal belt. The tensioner needs a special tool to service.
- What to do
- Have the belt and tensioner inspected at each service and replaced at the first sign of cracking or squealing.
Tire label lists the wrong wheel size (recall)
- What you'll notice
- No symptom; the tire and loading label lists the wrong rim size.
- Why it happens
- An incorrect label could lead a shop to fit the wrong replacement wheel. GM recall 03V-519 provides a correct label.
- What to do
- Check your VIN for open recall 03V-519 and confirm the correct wheel size before buying wheels.
Check engine light from loose or worn gas cap
- What you'll notice
- The check engine light comes on with no change in how the Vue drives, often after filling up.
- Why it happens
- A gas cap that is not clicked tight or has a worn seal lets fuel vapor escape, and the evaporative emissions system flags a leak.
- What to do
- Tighten the cap until it clicks and drive for a few days. If the light stays on, replace the cap and have the codes read.
Repair prices for your Saturn Vue
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace CVT with a remanufactured or used unit
- Replace 3-5-Reverse wave plate (transmission overhaul)
- Replace automatic transmission with remanufactured unit
- Rebuild or replace 4-speed automatic
- Replace timing chains, guides and tensioners
- Replace timing chain, guides and tensioner
- Replace steering column motor assembly or control module
- Replace power steering pump or steering rack
- Replace front wheel hub and bearing assembly (one side)
- Diagnose and replace body control module or engine computer
- Replace ignition lock cylinder or switch
- Replace crankshaft position sensor
- Replace fuel pump module and fuel line connectors
- Diagnose airbag system; replace sensor, module or wiring
- Replace clutch master and slave cylinders and bleed
- Replace gas cap
- Replace hybrid battery temperature sensor or cooling fan
- Replace serpentine belt and tensioner
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Inspect and tighten power steering line nut (recall 08V-470)No charge if your vehicle is included
- Replace ignition lock cylinder and keys (recall 14V-490)No charge if your vehicle is included
- Replace outside door handles (recall 09V-233)No charge if your vehicle is included
- Inspect and replace steering knuckles (recall 08V-616)No charge if your vehicle is included
- Replace seat belt anchor bolts (recall 01V-386)No charge if your vehicle is included
- Corrected tire label (recall 03V-519)No charge if your vehicle is included
- Hybrid battery repair or replacementNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.