Your 2004 Saturn Vueproblems, repair costs and recalls
What we've documented about the 2004 Saturn Vue: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2004 Saturn Vue
10 documented issues apply to 2004, most serious first.
VTi CVT transmission slips or fails
- What you'll notice
- The engine revs but the Vue barely moves, it jerks or shudders, makes whining or grinding noises, or will not go in Drive or Reverse.
- Why it happens
- Four-cylinder Vues with an automatic used GM's VTi continuously variable transmission (CVT), which failed often. GM stretched its warranty to 5 years/75,000 miles and later settled a class action covering 2002-2005 Vues.
- What to do
- Stop driving hard if it slips. Get a transmission diagnosis; failed units are usually replaced. Keep every receipt.
V6 5-speed automatic slips or shifts harshly
- What you'll notice
- Slipping, flaring revs between gears, harsh or late shifts, and a check engine light for gear ratio or torque converter codes.
- Why it happens
- The Honda-built 5-speed automatic used with the 3.5L V6 can wear its clutches and torque converter lockup, especially with old fluid.
- What to do
- Check the fluid and have the codes read. A fluid change sometimes helps if done early; slipping that keeps coming back usually means a rebuild or replacement.
Timing chain rattle and tensioner failure
- What you'll notice
- A rattle from the engine on cold start or at idle, cam timing codes, rough running, or a no-start in bad cases.
- Why it happens
- The timing chain tensioner and guides on the 2.2L Ecotec wear, and early engines did not oil the tensioner well at idle. Low oil makes it worse.
- What to do
- Keep the oil full. If the rattle persists, have the chain, guides and tensioner replaced before the chain skips and damages valves.
Electric power steering loses assist or feels jerky
- What you'll notice
- Steering suddenly gets heavy, or the assist lags and then over-corrects, sometimes with dash lights flickering.
- Why it happens
- First-generation Vues use electric power steering. Failures of the steering motor, its sensor or the body control module that feeds it cause loss of assist.
- What to do
- You can still steer, but slow down. Have the steering codes read; the steering column motor assembly or the control module is usually replaced.
Key can come out when not in Off (recall)
- What you'll notice
- You can remove the key even though the ignition is not fully in Off.
- Why it happens
- Wear in the ignition lock lets the key come out early, so an automatic might not be locked in Park and could roll away. GM recall 14V-490 fixes it.
- What to do
- Always set the parking brake. Check your VIN for open recall 14V-490.
Front wheel bearing hum or grinding
- What you'll notice
- A humming, growling or grinding noise that gets louder with speed and may change when turning, sometimes with an ABS light.
- Why it happens
- The front wheel bearing and hub assemblies wear out early on many first-generation Vues.
- What to do
- Have the bearing checked soon; a badly worn bearing can get loose. Replacing the hub assembly fixes it.
All lights flash and electrical glitches at start-up
- What you'll notice
- Every light on the car flashes after starting, the radio cuts out, locks stop working, or steering assist drops, often in cold weather.
- Why it happens
- Shops point to the body control module or main computer; owners report that new batteries and alternators did not fix it.
- What to do
- Have the battery tested first, then ask for a scan of body module codes. Write down when it happens so the shop can repeat it.
Manual clutch hydraulic leak
- What you'll notice
- The clutch pedal goes soft or to the floor and gears are hard to select, with fluid loss from the clutch reservoir.
- Why it happens
- The clutch master or slave cylinder hydraulic system can leak on manual-transmission Vues.
- What to do
- Check the clutch fluid level. If it keeps dropping, have the clutch hydraulics replaced before the pedal fails completely.
Tire label lists the wrong wheel size (recall)
- What you'll notice
- No symptom; the tire and loading label lists the wrong rim size.
- Why it happens
- An incorrect label could lead a shop to fit the wrong replacement wheel. GM recall 03V-519 provides a correct label.
- What to do
- Check your VIN for open recall 03V-519 and confirm the correct wheel size before buying wheels.
Check engine light from loose or worn gas cap
- What you'll notice
- The check engine light comes on with no change in how the Vue drives, often after filling up.
- Why it happens
- A gas cap that is not clicked tight or has a worn seal lets fuel vapor escape, and the evaporative emissions system flags a leak.
- What to do
- Tighten the cap until it clicks and drive for a few days. If the light stays on, replace the cap and have the codes read.
Repair prices for your 2004 Saturn Vue
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace CVT with a remanufactured or used unit
- Replace automatic transmission with remanufactured unit
- Replace timing chain, guides and tensioner
- Replace steering column motor assembly or control module
- Replace front wheel hub and bearing assembly (one side)
- Diagnose and replace body control module or engine computer
- Replace clutch master and slave cylinders and bleed
- Replace gas cap
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace ignition lock cylinder and keys (recall 14V-490)No charge if your vehicle is included
- Corrected tire label (recall 03V-519)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…