Subaru Crosstrekproblems, repair costs and recalls
Problems reported across 2013–2026. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
16 documented issues across all years, most serious first.
Engine burns oil between changes
- What you'll notice
- The oil level drops noticeably between oil changes, the low oil light comes on, or the dipstick reads low with no leak under the car.
- Why it happens
- Early versions of this engine had piston rings that let oil slip past and burn off. Subaru settled a class action and covered testing and engine repairs for a set period, which has now run out for most cars.
- What to do
- Check the oil level at every other fill-up and top it off right away if it is low. Running this engine low on oil can destroy it, so have a shop run an oil consumption test if it keeps dropping.
Engine valve springs can break
- What you'll notice
- A sudden ticking or rattling from the engine, rough running, a flashing check engine light, or the engine stalling and not restarting.
- Why it happens
- A batch of valve springs was not strong enough and can crack over time. A broken spring lets the engine misfire or quit while driving. Subaru recalled these cars to replace the springs.
- What to do
- Check the VIN for open recall 18V772 and have it done before driving much further. If the engine starts making a new noise or stalls, stop driving and have it towed to a dealer.
Engine computer can overheat an ignition coil and stall the engine
- What you'll notice
- The engine suddenly loses power or stalls while driving, will not restart, or the check engine light comes on with a misfire.
- Why it happens
- The engine computer can keep feeding power to an ignition coil after the engine is switched off. The coil overheats, can short out and blow a fuse, and the engine then shuts down.
- What to do
- Check the VIN for recalls 19V743 and 21V264 and have them done promptly. If the engine stalls or misfires, have the car towed to a dealer instead of driving it.
PCV valve can break apart and send pieces into the engine
- What you'll notice
- Blue or white smoke from the tailpipe, oil level dropping quickly, or a sudden loss of power.
- Why it happens
- The small crankcase ventilation valve on the engine can come apart. Pieces can be drawn into the engine, and oil gets pulled in and burned, which can end in engine damage.
- What to do
- Check the VIN for recall 19V744 (or 19V856 on some 2019 cars). If you see heavy smoke or lose power, pull over, shut the engine off and have it towed.
Wiring behind the dashboard can rub on a bracket and short out
- What you'll notice
- A burning smell, blown fuses, warning lights, or electrical features cutting out.
- Why it happens
- A wiring harness behind the instrument panel can touch a metal bracket. Over time the insulation can wear through and short, which is a fire risk.
- What to do
- Check the VIN for recall 23V551 and have it inspected right away. If you smell burning or see smoke, park outside and do not drive it.
Hybrid fuel cap seal can let fuel spill
- What you'll notice
- A strong gasoline smell around the filler door, or fuel seeping out when the tank is close to full.
- Why it happens
- The seal on the fuel cap of the hybrid model may not close off the filler properly, so fuel can escape. Leaking fuel near a hot or sparking part is a fire risk.
- What to do
- Check the VIN for recall 26V106 and have the cap replaced. Avoid topping off the tank until then, and do not drive if you see fuel leaking.
Front driveshaft can crack and break (recall 23V-754)
- What you'll notice
- Clicking or clunking from the front when accelerating or turning, then a loss of drive even though the engine runs.
- Why it happens
- The outer race of the front driveshaft joint can crack and come apart. If it breaks, the car may also roll when left in Park.
- What to do
- Stop driving and check the VIN for this recall. The driveshaft is replaced free of charge.
Front ball joint nut can be loose (do-not-drive recall 26V-685)
- What you'll notice
- Clunking or knocking from the left front over bumps, or the steering feeling loose and wandering.
- Why it happens
- The castle nut holding the left front lower ball joint may not have been tightened, so the joint can pull apart and the wheel can fold under the car.
- What to do
- Do not drive the car. Subaru has issued a do-not-drive warning for this recall, so arrange a tow to the dealer for the free repair.
Brake light switch can stop working
- What you'll notice
- Brake lights that do not come on, a shifter that will not move out of Park, a push-button start that will not respond, or stability control and other warning lights on the dash.
- Why it happens
- Fumes from some cleaning and care products used inside the car can coat the contacts in the brake light switch, so it stops sending a signal when the pedal is pressed.
- What to do
- Check the VIN for recall 19V149 and have the switch replaced. Ask someone to confirm the brake lights work in the meantime, because drivers behind you may not know you are stopping.
CVT automatic can shudder, jerk or stall
- What you'll notice
- Shuddering or bucking at low speed, a jolt when stopped that feels like a tap from behind, the engine stalling as the car comes to a stop, or fluid spots under the front of the car.
- Why it happens
- The first-generation continuously variable automatic had enough complaints that Subaru stretched the transmission warranty to ten years or 100,000 miles on these model years, and issued bulletins for leaks and stalling.
- What to do
- The extended coverage has aged out, so have a Subaru-experienced shop check the fluid condition, look for leaks and scan for transmission codes before the problem gets worse.
Rear stabilizer bar bracket bolts can work loose
- What you'll notice
- A clunk or rattle from the rear of the car over bumps, or more body lean than usual in turns.
- Why it happens
- The bolts holding the rear stabilizer bar brackets may not stay tight. A loose bracket can let the bar shift or come free.
- What to do
- Check the VIN for recall 21V263 and have the bolts replaced and tightened. Have any new rear-end clunk looked at soon.
Plug-in hybrid 12-volt charging connection can corrode
- What you'll notice
- Repeated 12-volt battery warnings, a slow or dead start, or the hybrid system shutting down and leaving you without drive power.
- Why it happens
- The terminal between the DC converter and the 12-volt battery can corrode. The corroded terminal heats up and can eventually break the connection.
- What to do
- Have the VIN checked for this recall and the terminal bracket replaced. Get it done promptly, since the car can quit without warning.
Water can get into the gear position switch (recall 23V-755)
- What you'll notice
- The reverse lights and the backup camera stop working when you select reverse, and the dash may show a transmission warning.
- Why it happens
- A weld on the inhibitor switch housing lets water inside, which corrodes the switch so it no longer reports which gear is selected.
- What to do
- Have the VIN checked and the switch replaced. Until then look over your shoulder when backing up, because the camera may not come on.
Windshield cracks or chips at very low mileage
- What you'll notice
- A crack spreading across the windshield on a nearly new car, sometimes after a small stone and sometimes with no sign of an impact at all.
- Why it happens
- Owners report the factory glass on these years chips and splits easily, and a chip near the driver-assist camera bracket often cannot be filled, so the whole windshield has to come out.
- What to do
- Get a chip repaired before it runs across your view. If the glass is replaced, make sure the shop recalibrates the camera behind the mirror, or the lane and braking aids can behave oddly.
Passenger door will not lock
- What you'll notice
- One door stays unlocked no matter whether you use the key fob, the inside switch or the handle, often with a clicking sound from that door while the others lock.
- Why it happens
- The small motor in the door that moves the lock fails, so the latch never gets the command to lock.
- What to do
- Have the door lock actuator replaced under warranty. The car still drives normally, but treat it as a security problem and do not leave valuables inside.
Driver's door mirror shakes at highway speed
- What you'll notice
- The view in the driver's side mirror blurs or jitters once you are up to highway speed, making it hard to judge traffic behind you.
- Why it happens
- The mirror glass and housing vibrate on their mount. Subaru has published a service bulletin that replaces the mirror and adds insulation, though some owners say the shake returns.
- What to do
- Ask a dealer to check it against the bulletin while the car is in warranty. It is a nuisance rather than a hazard, but a mirror you cannot read is worth fixing.
Repair prices for your Subaru Crosstrek
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace engine short block (piston ring fix)
- Replace engine valve springs
- Replace brake light switch
- Replace CVT valve body or torque converter
- Reprogram engine computer and replace ignition coil
- Replace PCV valve
- Replace and torque rear stabilizer bracket bolts
- Inspect and repair 12-volt charging terminal
- Inspect and reroute instrument panel wiring harness
- Replace fuel filler cap
- Replace transmission inhibitor switch
- Replace front driveshaft assembly
- Inspect and replace front lower ball joint and nut
- Replace windshield and recalibrate the driver-assist camera
- Replace door lock actuator
- Replace driver's door mirror assembly
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.