Your 2000 Subaru Legacyproblems, repair costs and recalls
What we've documented about the 2000 Subaru Legacy: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2000 Subaru Legacy
6 documented issues apply to 2000, most serious first.
Head gasket leaks
- What you'll notice
- Oil or coolant seeping from where the cylinder heads meet the engine block, a sweet coolant smell, the coolant level dropping, the temperature gauge rising, or a rough idle with misfire codes.
- Why it happens
- The 2.5L four-cylinder of these years used head gaskets that break down with age. On the 1996-1999 engine they tend to fail inside and cause overheating; on 2000 and later engines they usually start as slow outside leaks of oil and coolant.
- What to do
- Check coolant and oil levels often and watch the temperature gauge. If it starts to overheat, pull over and shut it off. Get a cooling system pressure test, and plan the repair before a small leak becomes an overheated engine.
Timing belt breaks and damages the engine
- What you'll notice
- The engine suddenly stops while driving, then cranks but will not start. There may be no warning at all.
- Why it happens
- These engines use a rubber timing belt, and the valves and pistons can hit each other if it breaks or skips. Belts that are past their replacement interval, or worn idler pulleys and the belt tensioner, are the usual cause.
- What to do
- If your service records do not show a timing belt change on schedule, have it done now along with the idlers and tensioner. If the belt already broke, do not keep cranking the engine; have it towed and checked for bent valves.
Automatic transmission slipping or slow to engage
- What you'll notice
- A delay or a clunk when shifting into Drive, slipping or flaring between gears, or the car not wanting to move at all.
- Why it happens
- Owners of these years report worn automatic transmissions, often after high mileage. Old or low fluid and internal clutch wear are common causes.
- What to do
- Check the fluid level and condition. If it slips or will not engage, avoid hard driving and get a transmission diagnosis; a rebuild or used unit is often needed.
Engine bearing failure and knocking
- What you'll notice
- A deep knocking from the engine that gets louder with speed, low oil pressure, and sometimes the engine seizing.
- Why it happens
- Owners of 2000 Legacys reported crankshaft and rod bearing failures at fairly low mileage. Once a bearing wears through, the engine is badly damaged.
- What to do
- If you hear a new knock, stop driving and check the oil level. Keep oil changes on time. A knocking engine usually needs a replacement or rebuild.
Rear subframe can rust and break (recall)
- What you'll notice
- Clunks from the rear, odd handling, or visible heavy rust under the back of the car.
- Why it happens
- Rear subframes with poor paint can rust through in salt areas and break.
- What to do
- Check your VIN and have the rear subframe inspected.
Free under recall 03V-153. Check the VIN first.
AWD binding in tight turns (automatic)
- What you'll notice
- In tight, slow turns such as parking lots, the car feels like it is braking itself, the tires scrub or hop, and the steering feels heavy.
- Why it happens
- On automatic all-wheel-drive Legacys of this era, the transfer clutch that splits power front to rear can stay locked when it should slip. A sticking transfer (duty C) solenoid, worn clutch plates, or mismatched tire sizes are the usual causes.
- What to do
- First make sure all four tires are the same brand, size and wear, and that the transmission fluid is full and clean. If it still binds, have a Subaru-savvy shop test the transfer solenoid before parts wear further.
Repair prices for your 2000 Subaru Legacy
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace both head gaskets and resurface heads
- Replace AWD transfer (duty C) solenoid
- Replace timing belt, idlers and tensioner
- Replace automatic transmission with used or rebuilt unit
- Replace engine with used or remanufactured unit
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Inspect and replace rear subframeNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…