Your 2007 Subaru WRXproblems, repair costs and recalls
What we've documented about the 2007 Subaru WRX: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2007 Subaru WRX
8 documented issues apply to 2007, most serious first.
STI piston ringland failure
- What you'll notice
- Blue or gray smoke from the exhaust, oil level dropping between changes, a rough idle or misfire on one cylinder, and sometimes a sudden loss of power.
- Why it happens
- The 2.5L turbo engine in the STI uses cast pistons with a thin ledge (ringland) that holds the piston rings. Engine knock (detonation) from low-octane fuel, a lean mixture or an aggressive tune can crack that ledge, so the cylinder loses compression and burns oil.
- What to do
- Use the premium fuel the car calls for and avoid untested tunes. If you see smoke or a misfire, stop hard driving and ask for a compression and leak-down test before more damage is done.
WRX piston ringland failure
- What you'll notice
- Rising oil use, blue smoke, a misfire on one cylinder or low compression on a test.
- Why it happens
- The 2.5L turbo WRX engine shares the STI's weak point: the ledge in the piston that holds the rings can crack after repeated engine knock, especially on modified cars or with low-octane fuel.
- What to do
- Track how much oil the engine uses. If it climbs, or a single-cylinder misfire code appears, have compression and leak-down tested to confirm before deciding on a repair.
Timing belt breaks or jumps a tooth
- What you'll notice
- A squeal or chirp from the front of the engine, then the engine suddenly quits and cranks fast without starting.
- Why it happens
- The older EJ boxer engines use a rubber timing belt with a 105,000-mile replacement interval. These are interference engines, so if the belt snaps or skips, pistons can hit the valves and wreck the engine.
- What to do
- Check your records and replace the belt, tensioner, idlers and water pump on time. If it has already failed, do not keep cranking it; have the valves checked before anything else.
Five-speed manual grinds or pops out of gear
- What you'll notice
- Grinding going into second or third, a gear that pops out, or a whine that rises with road speed.
- Why it happens
- The five-speed manual in the regular WRX (not the STI) wears internally, especially on cars that were launched hard or given more power.
- What to do
- Have the gearbox oil checked and the noise diagnosed. A clutch that does not fully release can feel similar, so rule that out first. Worn synchros or gears mean a rebuild or a used gearbox.
Passenger airbag inflator can rupture (recall)
- What you'll notice
- No warning in normal driving. In a crash the passenger airbag inflator can burst and throw metal pieces.
- Why it happens
- These cars used Takata passenger airbag inflators whose propellant breaks down after years of heat and humidity. Some cars needed a second replacement.
- What to do
- Treat this as urgent. Check the VIN for recalls 20V-001/002/003 and the earlier 18V and 19V campaigns; the dealer replaces the inflator for free.
Free at any Subaru dealer under the recall. Check your VIN first.
Oil leaks at the front of the engine and AVCS faults
- What you'll notice
- Oil dripping from the front of the engine, a burning oil smell, a rough idle or a check engine light for cam timing.
- Why it happens
- On the 2.5L turbo engines, the seals around the variable valve timing (AVCS) cam sprockets can seep oil, and the oil control valves that run the system can clog or fail, especially if oil changes were stretched.
- What to do
- Keep oil changes on schedule and look for drips. A cam timing code is usually a sticky oil control valve or low oil; a front seal leak should be fixed before it soaks the timing belt.
STI six-speed grinds in fifth or sixth gear
- What you'll notice
- Grinding when shifting into fifth or sixth gear.
- Why it happens
- The synchronizers in the STI six-speed gearbox wear, so the gears do not match speeds smoothly before engaging.
- What to do
- Try a fresh fluid change first. If grinding continues, plan for a synchro rebuild before gears are damaged.
Check engine light from the knock sensor
- What you'll notice
- The check engine light comes on with a knock sensor code. The car may feel slightly down on power.
- Why it happens
- The knock sensor on these engines can fail or lose its connection. RepairPal notes the code often appears even when the sensor tests fine, so the wiring and mounting are worth checking first.
- What to do
- Have the code read and the sensor wiring and connector inspected. The engine pulls back timing when knock readings are bad, so do not ignore it on a turbo car.
Repair prices for your 2007 Subaru WRX
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace short block or engine assembly
- Replace timing belt kit and water pump
- Replace cam seals or AVCS oil control valve
- Replace knock sensor
- Rebuild manual transmission
- Replace transmission synchros
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace passenger airbag inflatorNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…