Your 2018 Subaru WRXproblems, repair costs and recalls
What we've documented about the 2018 Subaru WRX: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2018 Subaru WRX
9 documented issues apply to 2018, most serious first.
STI piston ringland failure
- What you'll notice
- Blue or gray smoke from the exhaust, oil level dropping between changes, a rough idle or misfire on one cylinder, and sometimes a sudden loss of power.
- Why it happens
- The 2.5L turbo engine in the STI uses cast pistons with a thin ledge (ringland) that holds the piston rings. Engine knock (detonation) from low-octane fuel, a lean mixture or an aggressive tune can crack that ledge, so the cylinder loses compression and burns oil.
- What to do
- Use the premium fuel the car calls for and avoid untested tunes. If you see smoke or a misfire, stop hard driving and ask for a compression and leak-down test before more damage is done.
Rod bearing knock and spun bearings
- What you'll notice
- A deep, rhythmic knock from low in the engine that gets louder with revs or load. The oil pressure light may flicker, and metal flakes can show up in the oil or filter.
- Why it happens
- The bearings between the crankshaft and connecting rods in the 2.5L turbo engines can wear or spin, often after oil starvation or low oil. Subaru extended short-block coverage for some bearing failures on 2012-2014 WRX and 2012-2017 STI cars under bulletin 02-181-19.
- What to do
- Stop driving if you hear a new deep knock, since a spun bearing can quickly destroy the engine. Check the oil level, get it towed for diagnosis, and ask a Subaru dealer whether the extended coverage still applies to your VIN.
Timing belt breaks or jumps a tooth
- What you'll notice
- A squeal or chirp from the front of the engine, then the engine suddenly quits and cranks fast without starting.
- Why it happens
- The older EJ boxer engines use a rubber timing belt with a 105,000-mile replacement interval. These are interference engines, so if the belt snaps or skips, pistons can hit the valves and wreck the engine.
- What to do
- Check your records and replace the belt, tensioner, idlers and water pump on time. If it has already failed, do not keep cranking it; have the valves checked before anything else.
Low-pressure fuel pump can fail (recall)
- What you'll notice
- The engine runs rough, stalls while driving or will not restart.
- Why it happens
- The in-tank fuel pump can stop working.
- What to do
- Check the VIN for recall 21V-587. The dealer replaces the pump for free.
Free at any Subaru dealer under the recall. Check your VIN first.
Carbon buildup on intake valves
- What you'll notice
- Rough idle, stumbling on a cold start, misfire codes that come back after new plugs and coils, and a car that feels down on power.
- Why it happens
- The 2.0L turbo engine sprays fuel straight into the cylinders, so fuel never washes the backs of the intake valves. Oily vapor from the crankcase vent bakes onto them over time. Subaru bulletin 02-193-24 describes a walnut-shell cleaning procedure.
- What to do
- Have plugs, coils, injectors and vacuum leaks ruled out first. If carbon is confirmed, a walnut-blast cleaning fixes it; fuel additives cannot reach this area.
Oil leaks at the front of the engine and AVCS faults
- What you'll notice
- Oil dripping from the front of the engine, a burning oil smell, a rough idle or a check engine light for cam timing.
- Why it happens
- On the 2.5L turbo engines, the seals around the variable valve timing (AVCS) cam sprockets can seep oil, and the oil control valves that run the system can clog or fail, especially if oil changes were stretched.
- What to do
- Keep oil changes on schedule and look for drips. A cam timing code is usually a sticky oil control valve or low oil; a front seal leak should be fixed before it soaks the timing belt.
Clutch slips, shudders or wears out early
- What you'll notice
- The clutch slips under load, shudders when pulling away, chirps or whirs when the pedal is pressed, or the pedal feels heavy or inconsistent.
- Why it happens
- Manual 2015 to early 2018 cars had clutch, release bearing and pedal parts that Subaru later revised under bulletin 03-79-18. Clutch problems are the most-reported WRX complaint on CarComplaints, often around 14,000 miles.
- What to do
- Have the clutch and its hydraulics inspected. If the clutch is replaced, ask for the updated parts from the bulletin, and check whether any warranty coverage applies.
Backup light switch can corrode (recall)
- What you'll notice
- The reverse lights do not come on and the rearview camera image does not appear when you shift into reverse.
- Why it happens
- The switch on the transmission that signals reverse gear can corrode and stop working.
- What to do
- Check the VIN for recall 22V-522. The dealer replaces the switch if needed.
Free at any Subaru dealer under the recall. Check your VIN first.
Battery drains when the car sits
- What you'll notice
- The car will not start after sitting for a few days, or the battery dies early.
- Why it happens
- A class-action lawsuit claimed the electrical system keeps drawing power after shutdown. Subaru denied it, but a 2023 settlement extended coverage for some battery failures.
- What to do
- Have the battery and parasitic draw tested, keep receipts, and ask a dealer whether the settlement coverage applies to your car.
Repair prices for your 2018 Subaru WRX
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace short block or engine assembly
- Walnut-blast clean intake valves
- Replace timing belt kit and water pump
- Replace cam seals or AVCS oil control valve
- Replace clutch kit and resurface or replace flywheel
- Test parasitic draw and replace 12V battery
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace in-tank fuel pumpNo charge if your vehicle is included
- Inspect and replace backup light switchNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…