Your 1999 Toyota Land Cruiserproblems, repair costs and recalls
What we've documented about the 1999 Toyota Land Cruiser: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1999 Toyota Land Cruiser
9 documented issues apply to 1999, most serious first.
Brake booster or ABS pump fails and the pedal goes hard
- What you'll notice
- A buzzer and brake/ABS warning lights, a whining noise from the brake unit, then a brake pedal that needs much more force or sinks far down.
- Why it happens
- These trucks use a hydraulic brake booster and ABS actuator instead of a vacuum booster. The pump, accumulator or actuator can wear out, cutting brake assist.
- What to do
- Treat brake warning lights as urgent and drive gently to a shop. A scan for ABS codes will show whether the booster pump, accumulator or actuator is at fault.
Timing belt and water pump past due
- What you'll notice
- Usually no warning. A worn belt can snap and the engine suddenly stops and won't restart. A leaking water pump may show coolant at the front of the engine first.
- Why it happens
- The 4.7L V8 uses a rubber timing belt that must be replaced on schedule, together with the water pump it drives. Many used trucks have missed this service.
- What to do
- If there is no record of it, have the timing belt, water pump, tensioner and idlers replaced. Roughly every 90,000 to 100,000 miles is the usual interval.
Torque converter failure on the 4-speed automatic
- What you'll notice
- Shudder at steady speeds, slipping, flaring revs or harsh shifts, sometimes followed by loss of drive.
- Why it happens
- The torque converter in the earlier 4-speed automatic is a known failure point on these trucks.
- What to do
- Check the fluid level and condition and get a transmission diagnosis early. A fluid service can help a mild shudder, but a failed converter has to be replaced.
Rust on the rear body, tailgate and frame
- What you'll notice
- Bubbling paint or holes along the rear sills, wheel arches, around the tailgate and window seams, or flaky rust on the rear frame.
- Why it happens
- Road salt and coastal air eat into these areas on older Land Cruisers, especially trucks that towed boats or were driven in snow states.
- What to do
- Inspect the underside and body seams once a year. Treat surface rust early; badly rotted frame or body sections need a body shop.
Height control suspension sags or rides hard
- What you'll notice
- A bouncy or harsh ride, the front end sitting low, the truck not changing height, or a suspension warning light.
- Why it happens
- Trucks with Active Height Control use hydraulic fluid and nitrogen-filled spheres in place of normal springs. The spheres lose charge with age, and the system can leak. The later KDSS system can also leak at its valves.
- What to do
- Have a shop that knows Land Cruisers check the fluid and sphere pressures. Refreshing the spheres and fluid often fixes it; some owners convert to regular springs.
Front CV joints click when turning
- What you'll notice
- Clicking or knocking from the front wheels when pulling away or turning at full lock.
- Why it happens
- The outer joints on the front drive shafts wear out, especially if a split boot let dirt and water in.
- What to do
- Look for torn rubber boots behind the front wheels. Replace the worn drive shaft before the joint breaks.
Plastic heater hose tees crack and leak coolant
- What you'll notice
- Sweet coolant smell, coolant on top of the engine or under the truck, or the heater blowing cold. A failed heater core can fog the windows.
- Why it happens
- Plastic T-fittings in the heater hoses get brittle with heat and age and crack. Heater cores can also leak with age.
- What to do
- Replace the plastic tees with metal or new factory parts before they break, and check the heater hoses at the same time.
Starter clicks but won't crank
- What you'll notice
- A single click or nothing at all when you turn the key or press start, often more often when hot, with a good battery.
- Why it happens
- The contacts inside the starter wear out on the V8 trucks, and starters on these Land Cruisers fail at higher mileage. On the V8s the starter sits under the intake, so it is a big job.
- What to do
- Have the battery and connections tested first. If the starter is at fault, replace it or, on the 4.7L, have the starter contacts renewed.
Power steering hoses and rack leak
- What you'll notice
- Power steering fluid low or on the ground, a whine when turning, or a damp steering rack.
- Why it happens
- The return hoses from the reservoir and the rack seals harden with age and start to seep.
- What to do
- Top up and find the source. Hoses are cheap; a leaking rack may need resealing or replacing.
Repair prices for your 1999 Toyota Land Cruiser
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Treat rust and weld in repair sections
- Replace hydraulic brake booster pump/accumulator or ABS actuator
- Replace timing belt, water pump, tensioner and idler pulleys
- Replace height control spheres and flush suspension fluid
- Replace torque converter or install remanufactured automatic transmission
- Replace front drive shaft (CV axle), one side
- Replace heater hose tees and hoses, refill coolant
- Replace power steering return hoses or reseal steering rack
- Replace starter (or starter contacts on the 4.7L)
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…