Your 2019 Toyota Land Cruiserproblems, repair costs and recalls
What we've documented about the 2019 Toyota Land Cruiser: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2019 Toyota Land Cruiser
9 documented issues apply to 2019, most serious first.
Passenger seat belt sensor wire can break and turn off airbags (recall)
- What you'll notice
- The airbag warning light may come on, or the passenger airbag 'off' light may show with an adult in the seat.
- Why it happens
- A wiring harness for the front passenger seat belt tension sensor can wear and break, switching off the passenger front, knee and seat side airbags.
- What to do
- Check your VIN for open recalls. A Toyota dealer modifies or replaces the passenger seat belt assembly for free.
Height control suspension sags or rides hard
- What you'll notice
- A bouncy or harsh ride, the front end sitting low, the truck not changing height, or a suspension warning light.
- Why it happens
- Trucks with Active Height Control use hydraulic fluid and nitrogen-filled spheres in place of normal springs. The spheres lose charge with age, and the system can leak. The later KDSS system can also leak at its valves.
- What to do
- Have a shop that knows Land Cruisers check the fluid and sphere pressures. Refreshing the spheres and fluid often fixes it; some owners convert to regular springs.
Starter clicks but won't crank
- What you'll notice
- A single click or nothing at all when you turn the key or press start, often more often when hot, with a good battery.
- Why it happens
- The contacts inside the starter wear out on the V8 trucks, and starters on these Land Cruisers fail at higher mileage. On the V8s the starter sits under the intake, so it is a big job.
- What to do
- Have the battery and connections tested first. If the starter is at fault, replace it or, on the 4.7L, have the starter contacts renewed.
Secondary air injection pump or valve failure
- What you'll notice
- Check engine light, sometimes with flashing 4WD or traction lights and reduced power right after a cold start.
- Why it happens
- A small air pump blows air into the exhaust for a few seconds on cold starts to cut emissions. Moisture gets into the pump and its valves, and they corrode and fail.
- What to do
- Have the codes read. The truck usually drives fine, but replace the failed pump or valve so emissions and stability systems work normally.
Radiator cracks and leaks coolant
- What you'll notice
- Pink coolant drips at the front of the truck, a falling coolant level, or the temperature rising when towing.
- Why it happens
- The plastic radiator tanks crack with age and heat. In a large owner poll it was the most common repair on these trucks.
- What to do
- Check the radiator seams for pink crust or drips. Replace the radiator before it fails on the road, and do not drive if it overheats.
Water pump leaks
- What you'll notice
- Coolant drips at the front of the engine, a dried pink crust near the pump, or a slowly dropping coolant level.
- Why it happens
- The water pump seal wears out and starts to weep. It was the second most common repair in an owner poll.
- What to do
- Have it replaced when you see it leaking, along with the drive belt and thermostat if they are old.
Coolant leak from the valley plate at the back of the engine
- What you'll notice
- A coolant drip at the back of the engine near the transmission, coolant smell, and a slowly dropping level.
- Why it happens
- A coolant passage plate sits in the valley between the cylinder banks. Its seal can fail, letting coolant run down the back of the engine.
- What to do
- Have a shop confirm where the leak is coming from. The intake has to come off, so it makes sense to replace other aging seals at the same time.
Cam tower and timing cover oil leaks
- What you'll notice
- Oil seeping down the sides or front of the engine, burning oil smell, or drips under the truck.
- Why it happens
- The sealant between the camshaft housings and cylinder heads, and around the timing cover, can break down over time.
- What to do
- Small seeps can be watched. If it is dripping onto the exhaust, have it resealed; it is many hours of labor, so ask about doing the valley plate and water pump at the same time.
Clunk from the driveshaft when stopping or pulling away
- What you'll notice
- A slight jolt as you come to a stop, then a clunk from under the truck when you pull away.
- Why it happens
- The universal joints and slip joint on the driveshafts lose their grease, especially after water crossings or off-road use, and start to bind.
- What to do
- Have the driveshaft joints greased. If the clunk continues, the U-joints may need replacing.
Repair prices for your 2019 Toyota Land Cruiser
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace height control spheres and flush suspension fluid
- Replace starter (or starter contacts on the 4.7L)
- Replace secondary air pump and air switching valve(s)
- Replace radiator and refill coolant
- Replace water pump and drive belt, refill coolant
- Remove intake and replace valley coolant plate gasket
- Reseal cam towers and timing cover
- Grease driveshaft joints; replace worn U-joints if needed
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Modify or replace front passenger seat belt assemblyNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…