Toyota Miraiproblems, repair costs and recalls
Problems reported across 2016–2023. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
18 documented issues across all years, most serious first.
Hard to refuel: hydrogen stations closed, broken or out of fuel
- What you'll notice
- You can't find a working hydrogen station nearby, stations are closed for repair or out of hydrogen, pumps won't take payment or stop mid-fill, and there can be long lines. Some owners have run out of fuel and needed a tow.
- Why it happens
- The Mirai can only refuel at hydrogen stations, and there are few of them, almost all in California. Supply shortages, station breakdowns and rising hydrogen prices have hit owners hard, and Mirai owners have sued Toyota over it.
- What to do
- Check a live station-status app before every trip and don't let the tank run low. Keep a backup plan for longer drives. If you're thinking of buying one, make sure a reliable station is close to home and work.
"FC malfunction" warning with code P1DEF
- What you'll notice
- A message says "FC malfunction, return vehicle to dealer for service," and code P1DEF (fuel cell stack performance) is stored. Power may be reduced.
- Why it happens
- The fuel control module's settings could flag the fuel cell stack as underperforming. Toyota revised the fuel control module calibration in a service bulletin.
- What to do
- Have a Toyota dealer certified for fuel cell vehicles check it. The calibration update is covered, and key fuel cell parts carry an 8-year/100,000-mile warranty.
Automatic emergency braking activates with nothing ahead
- What you'll notice
- The car brakes hard on its own with no car or object in front and no warning first, which can startle you or cause a rear-end crash.
- Why it happens
- Owners report false triggers of the pre-collision braking system; the dealer could not find a fault in at least one case.
- What to do
- Report each event to the dealer and to NHTSA. Keep the front radar and camera area clean, and ask the dealer to check sensor aim and software.
Pre-collision braking or warnings act up
- What you'll notice
- The automatic emergency braking or forward collision warning goes off when nothing is there, or doesn't act as expected, sometimes leading to crashes.
- Why it happens
- Owners filed several NHTSA complaints about the forward collision avoidance system on 2022-2023 Mirais, including some that involved crashes. No single cause has been published.
- What to do
- Report every event to a Toyota dealer and NHTSA. Ask the dealer to check for software updates and sensor calibration.
Sudden loss of power with the screen going black
- What you'll notice
- The car suddenly loses drive power, and the center display may go black and reboot. Owners describe it happening at low speed and on the freeway.
- Why it happens
- NHTSA complaints describe sudden power loss without warning lights. The cause hasn't been confirmed, and dealers could not always reproduce it.
- What to do
- Get to a safe spot and restart the car. Report it to a Toyota fuel cell dealer and NHTSA right away, and ask the dealer to save stored codes.
Stability control may stay off after restart (recall)
- What you'll notice
- The stability control (VSC) may not turn back on when you restart the car, and the VSC off light may stay lit.
- Why it happens
- A software error in the skid control computer can leave stability control off after a restart.
- What to do
- Check your VIN for open recalls. The dealer updates the skid control software for free.
Fueling problems from a lost nozzle O-ring
- What you'll notice
- The car won't fill properly or the fill stops early, and the station may show a fueling fault. The rubber O-ring on the car's hydrogen fill port can come off during fueling.
- Why it happens
- Toyota found that some fueling sessions could pull off the 35 MPa O-ring on the Mirai's hydrogen receptacle, which affects the seal with the station nozzle.
- What to do
- If fills keep failing at more than one station, have a Toyota fuel cell dealer inspect the fill receptacle and O-ring.
Safety Connect may send the wrong location
- What you'll notice
- No obvious symptom, but if you use emergency assistance or crash notification, the system may report the wrong location.
- Why it happens
- A programming error in the data communication module made it miscalculate GPS position after November 2, 2019. Toyota fixed it under limited service campaign K0P.
- What to do
- Ask a Toyota dealer to check whether campaign K0P has been done on your VIN.
Free under a limited service campaign.
12-volt battery runs down when parked
- What you'll notice
- The car won't power on or shows electrical warnings after sitting for a while, especially if not driven daily.
- Why it happens
- Like other electrified Toyotas, the Mirai relies on a small 12-volt battery to start up its systems. Sitting, heat, cold and small electrical drains run it down, and Toyota has bulletins on 12-volt battery care.
- What to do
- Drive the car regularly or use a battery maintainer if it will sit. Have the 12-volt battery tested if you see repeated low-voltage warnings.
Check engine light from stuck fuel cell air valve
- What you'll notice
- The check engine light comes on with codes P1F6C71 (air sealing valve actuator stuck) or P1F6E71 (air pressure regulating valve actuator stuck).
- Why it happens
- The valves that control air flow to the fuel cell stack can be flagged as stuck. Toyota modified the EV control computer logic to make this less likely.
- What to do
- Have a Toyota fuel cell dealer read the codes and apply the EV control computer update from bulletin T-SB-0043-23.
False "FCV system malfunction" warning
- What you'll notice
- A "FCV system malfunction" warning appears on the dash even though the car seems to drive normally.
- Why it happens
- Improper programming of the EV control computer could trigger a false warning. Toyota fixed it with a software update under campaign 22TD01.
- What to do
- Ask a Toyota dealer whether campaign 22TD01 or a later EV control software update has been done on your car.
Free under a Toyota service campaign.
Backup camera image appears late (recall)
- What you'll notice
- When you shift into reverse, the backup camera picture takes a couple of seconds to appear.
- Why it happens
- The parking assist computer software was programmed incorrectly, delaying the rearview image.
- What to do
- Check your VIN for open recalls. The dealer updates the parking assist software for free.
Backup camera can freeze or go blank (recall)
- What you'll notice
- In reverse, the backup camera image can freeze or the screen can go blank on cars with the 360-degree Panoramic View Monitor.
- Why it happens
- A software error in the parking assist system.
- What to do
- Check your VIN for open recalls. The dealer updates the parking assist software for free.
Chirping noise from the rear at certain speeds
- What you'll notice
- A high-pitched chirp from the back of the car that shows up only at certain speeds.
- Why it happens
- Toyota issued a bulletin (T-SB-0286-17) for this rear chirp noise on some 2016-2017 cars, filed under the fuel system.
- What to do
- Point out the noise and the speed it happens at to a Toyota dealer and ask about bulletin T-SB-0286-17.
Seat heater stops working
- What you'll notice
- One or both front seat heaters don't warm up, and a light on the A/C control panel may not come on.
- Why it happens
- Toyota issued a bulletin for an inoperative seat heater and an unlit A/C panel indicator on these cars.
- What to do
- Have a dealer check the seat heater and panel against bulletin T-SB-0041-18.
Debris from the hydrogen tank end protector
- What you'll notice
- No symptoms while driving. Bits of debris are found on the underbody cover near the end of the hydrogen tank during service.
- Why it happens
- Toyota traced the debris to the protective cap on the end of the hydrogen tank.
- What to do
- Have a Toyota fuel cell dealer inspect the tank area at your next service. Hydrogen tanks should only be handled by trained technicians.
Navigation maps out of date or won't update
- What you'll notice
- The navigation maps are old, or a map or software update fails.
- Why it happens
- Cars with Premium Audio with Dynamic Navigation need a special Toyota USB service tool for map and software updates, so they often go without them.
- What to do
- Ask a Toyota dealer to install the latest map and head unit software.
Rear suspension creaks or clicks over bumps
- What you'll notice
- A creak or click from under the rear of the car when braking or driving over bumps.
- Why it happens
- Toyota traced the noise to the rear suspension member (subframe) and issued a bulletin with a repair.
- What to do
- Ask a Toyota dealer to check for bulletin T-SB-0047-23. It is usually covered under warranty.
Repair prices for your Toyota Mirai
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Fuel control module calibration update
- Inspect hydrogen fill receptacle and replace O-ring
- Noise diagnosis and bulletin repair
- Diagnose and repair seat heater
- Inspect hydrogen tank end protector and underbody cover
- Diagnose and recalibrate pre-collision radar/camera
- Diagnose and update driver-assist software
- Map and head unit software update
- Test and replace 12-volt battery
- EV control computer update per bulletin
- Diagnose fuel cell power loss and update software
- Repair rear suspension member per bulletin
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Data communication module software update (campaign K0P)No charge if your vehicle is included
- EV control computer software update (campaign 22TD01)No charge if your vehicle is included
- Skid control computer software updateNo charge if your vehicle is included
- Parking assist computer software updateNo charge if your vehicle is included
- Parking assist software updateNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.