Home › Toyota › MR2 Spyder › 2005
My vehicle

Your 2005 Toyota MR2 Spyderproblems, repair costs and recalls

What we've documented about the 2005 Toyota MR2 Spyder: problems owners and shops report, typical repair and upkeep costs, and safety recalls.

Ownership snapshot

Averages, not quotes
Problems documented for 2005113 rated serious
Safety recalls…Checking NHTSA

Routine maintenance costs (model-wide, not specific to one year or engine)

Oil and filter changeAbout every 5,000 miles · Check the oil level often: early engines can burn oil, and running low damages the engine.
Price not verified
Ask for an estimate
Front brake padsAbout every 30,000–50,000 miles
Price not verified
Ask for an estimate
Rear brake padsAbout every 30,000–60,000 miles · Rear calipers and parking brake cables can seize; have them checked at the same time.
Price not verified
Ask for an estimate
12V battery replacementAbout every 4 years
Price not verified
Ask for an estimate
Spark plug replacement (set of 4)About every 100,000–120,000 miles for iridium plugs · 2003-2005 cars cost a little more than 2000-2002 cars. The engine sits behind the seats.
Price not verified
Ask for an estimate
Engine coolant drain, refill and bleedFollow the owner's manual; usually every 2–5 years by coolant type · The mid-engine layout means long coolant pipes that must be bled of air. 2004-2005 cars cost less than 2000-2003 cars.
Price not verified
Ask for an estimate

The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.

Known problems for your 2005 Toyota MR2 Spyder

11 documented issues apply to 2005, most serious first.

Stop soon2000–2005Engine

Heavy oil consumption

What you'll notice
You need to add oil between changes, see blue-gray smoke, or find the dipstick low. Running low can lead to knocking and engine failure.
Why it happens
Early 1.8L engines can let oil slip past the piston rings and burn it. Toyota changed the rings and pistons during 2001 and 2002 production, so the earliest cars are worst, but high-mileage later cars can still burn oil.
What to do
Check the oil level every fill-up and keep it full. If it uses more than about a quart every 1,000-1,500 miles, have a compression and leak-down test done and the pre-cats inspected. If it knocks or the oil light comes on, stop and shut the engine off.
Repair costInsufficient verified pricing for this vehicle and repair
Replace short block (engine) or install a used engine. Prepare an itemized shop request.
Walk through this symptom: Oil level keeps dropping →
Stop soon2002–2005Transmission

SMT stalls, lurches or misshifts

What you'll notice
The car lurches, picks the wrong gear, shifts by itself, or stalls at low speed with the gear warning light on.
Why it happens
The SMT relies on an electronic control unit, a hydraulic pump, hydraulic lines and clutch and gear actuators. Owners report pump and actuator failures, and one reported a corroded hydraulic line that made the car lurch forward. Repairs are often costly.
What to do
Avoid traffic and highways if it misshifts or stalls, since it can lose drive suddenly. Have the codes read by a shop that knows the SMT; sometimes a used transmission costs less than repairing the parts.
Repair costInsufficient verified pricing for this vehicle and repair
Repair SMT hydraulic line, pump or actuator, or replace SMT control unit. Prepare an itemized shop request.
Walk through this symptom: Engine stalls while driving →
Stop soon2002–2005Transmission

SMT warning light, buzzing, or gears won't change

What you'll notice
On cars with the clutchless sequential manual (SMT), the SMT warning light comes on, you hear a buzzing from the engine compartment, or the car won't change gears.
Why it happens
Fluid can seep from the SMT hydraulic unit at the reservoir cap or its seals, so the pump runs longer and pressure drops. Toyota bulletin T-SB-0031-18 replaces two seal rings, then refills and bleeds the fluid.
What to do
If the car won't shift, park it safely and have it towed. Ask a Toyota dealer or SMT-savvy shop to read the codes and check bulletin T-SB-0031-18 before replacing major parts.
Repair costInsufficient verified pricing for this vehicle and repair
Replace SMT reservoir seal rings, refill and bleed fluid (T-SB-0031-18). Prepare an itemized shop request.
Get checked2000–2005Engine

Timing chain wear or variable valve timing fault (P1349)

What you'll notice
The check engine light comes on with code P1349, the engine idles rough or feels weak, or you hear a rattle from the timing chain.
Why it happens
The timing chain, its sprockets and the VVT-i gear can wear, especially when oil changes are skipped or the oil runs low. Toyota issued a bulletin for the P1349 code on these engines.
What to do
Check the oil level first. Have the oil control valve, its screen and the timing chain checked; catching chain wear early avoids engine damage.
Repair costInsufficient verified pricing for this vehicle and repair
Replace VVT oil control valve (timing chain tensioner if worn). Prepare an itemized shop request.
Get checked2000–2005Transmission

Manual transmission slips out of gear or shifter feels loose

What you'll notice
The car pops out of gear while driving, or the shifter feels sloppy and hard to place in gear.
Why it happens
Owners report gears slipping out on the 5-speed manual. Toyota also ran a service campaign on early cars to re-tighten loose shift control bracket bolts, and issued a bulletin on the shift cable bracket.
What to do
Have the shift cables, bracket and mounts checked. If it keeps popping out of gear, hold the lever only as long as needed to get it inspected; worn internal parts need a transmission repair.
Repair costInsufficient verified pricing for this vehicle and repair
Inspect shift linkage and re-torque shift bracket bolts. Prepare an itemized shop request.
Walk through this symptom: Transmission slipping →
Get checked2000–2005Body

Worn, torn or broken convertible top

What you'll notice
Rain gets in around or through the soft top, the fabric is split or frayed, or the rear window is cracked or loose from the top.
Why it happens
The soft top fabric and its sewn-in rear window wear with age, sun and folding. Because the rear glass is part of the top, damage to the window usually means replacing the whole top.
What to do
Keep water out with a temporary cover and dry the interior. Get quotes for a replacement top; many owners buy an aftermarket top and have an upholstery shop fit it.
Repair costInsufficient verified pricing for this vehicle and repair
Replace soft top with glass rear window. Prepare an itemized shop request.
Get checked2000–2005Body

Water inside from clogged convertible top drains

What you'll notice
Wet carpet, a damp or musty smell, or water pooling behind the seats after rain or a car wash.
Why it happens
Rain off the soft top runs out through small one-way drain valves behind the side air scoops. They clog with dirt and leaves, and trapped water can rust the floor over time.
What to do
Have the side scoop trims removed and the drains cleaned. Dry the carpet fully and look for rust underneath.
Repair costInsufficient verified pricing for this vehicle and repair
Clear top drain valves and dry carpet. Prepare an itemized shop request.
Get checked2000–2005Brakes

Parking brake cable or rear caliper sticking

What you'll notice
The parking brake won't release fully, a rear wheel drags or gets hot, or the parking brake doesn't hold well.
Why it happens
The parking brake cables and rear calipers corrode and seize, especially on cars that sit or see road salt.
What to do
If a wheel is hot or the car pulls, have the brakes checked soon. Seized cables and calipers are usually replaced.
Repair costInsufficient verified pricing for this vehicle and repair
Replace parking brake cable. Prepare an itemized shop request.
Walk through this symptom: Brakes dragging →
Monitor2000–2005Emissions

Oxygen sensor failure

What you'll notice
The check engine light is on, fuel economy drops, or the car fails an emissions test.
Why it happens
The MR2 Spyder has three oxygen sensors. The one after the main catalytic converter fails most often.
What to do
Have the codes read to see which sensor is at fault. It is not urgent, but fix it before inspection and check oil use too, since oil burning can foul sensors.
Repair costInsufficient verified pricing for this vehicle and repair
Replace oxygen sensor. Prepare an itemized shop request.
Monitor2000–2005Exhaust

Rattle from loose exhaust heat shields

What you'll notice
A tinny rattle from behind the seats or under the car, often at certain engine speeds.
Why it happens
Exhaust heat shields loosen or rust around their fasteners. Owners also report engine rattles at all speeds, which need checking because pre-cat or timing chain trouble can sound similar.
What to do
Have a shop find the source. A loose shield is cheap to clamp, but rule out the pre-cats and timing chain first.
Repair costInsufficient verified pricing for this vehicle and repair
Diagnose noise and clamp or refasten heat shield. Prepare an itemized shop request.
Monitor2000–2005Electrical

Crankshaft sensor code (P0335) from a weak battery

What you'll notice
The check engine light comes on with code P0335, sometimes after slow cranking.
Why it happens
Toyota found that low battery voltage while cranking can set this crankshaft sensor code even when the sensor is fine.
What to do
Have the battery and charging system tested before replacing the sensor.
Repair costInsufficient verified pricing for this vehicle and repair
Test and replace 12V battery. Prepare an itemized shop request.
Price guide

Repair prices for your 2005 Toyota MR2 Spyder

Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.

  • Replace short block (engine) or install a used engine
  • Repair SMT hydraulic line, pump or actuator, or replace SMT control unit
  • Replace SMT reservoir seal rings, refill and bleed fluid (T-SB-0031-18)
  • Replace VVT oil control valve (timing chain tensioner if worn)
  • Inspect shift linkage and re-torque shift bracket bolts
  • Replace soft top with glass rear window
  • Clear top drain valves and dry carpet
  • Replace parking brake cable
  • Replace oxygen sensor
  • Diagnose noise and clamp or refasten heat shield
  • Test and replace 12V battery
Get help with a shop quote →

Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.

Safety recalls for the 2005 Toyota MR2 Spyder
Checking the NHTSA recall database…
Keep a copy of this pageDownload the snapshot, every problem, the repair costs and the recalls for your 2005 Toyota MR2 Spyder as a PDF you can save, print or bring to your shop.
This page is a general guide based on widely reported problems. Not every vehicle is affected, and it doesn't replace an in-person diagnosis.