Home › Toyota › Sequoia › 2003
My vehicle

Your 2003 Toyota Sequoiaproblems, repair costs and recalls

What we've documented about the 2003 Toyota Sequoia: problems owners and shops report, typical repair and upkeep costs, and safety recalls.

Ownership snapshot

Averages, not quotes
Problems documented for 200372 rated serious
Safety recalls…Checking NHTSA

Routine maintenance costs (model-wide, not specific to one year or engine)

Synthetic oil and filter changeEvery 5,000–10,000 miles, by model year · V8 engines take 7–8 quarts of oil; the hybrid V6 uses 0W-20 synthetic.
Price not verified
Ask for an estimate
Front brake pads and rotorsAbout every 30,000–60,000 miles
Price not verified
Ask for an estimate
Rear brake pads and rotorsAbout every 40,000–70,000 miles · All Sequoias use rear disc brakes.
Price not verified
Ask for an estimate
12V battery replacementAbout every 4–7 years
Price not verified
Ask for an estimate
Spark plug replacementAbout every 60,000–120,000 miles, by engine · V8 engines have 8 plugs with tight access, so labor runs high.
Price not verified
Ask for an estimate
Engine coolant drain and refillFirst at 100,000 miles, then every 50,000 miles
Price not verified
Ask for an estimate

The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.

Known problems for your 2003 Toyota Sequoia

7 documented issues apply to 2003, most serious first.

Stop soon2001–2007Suspension

Front lower ball joint wear and separation (recall)

What you'll notice
Clunking from the front over bumps, steering that wanders, uneven wear on the inner edge of the front tires, and in the worst case a front wheel that suddenly folds under the truck.
Why it happens
The front lower ball joints on these trucks can wear out far too early. Toyota recalled 2002-2004 trucks because the ball surface could be scratched at the factory, and 2004-2007 trucks because the grease inside could break down. Some aftermarket replacement joints were also recalled for being too soft.
What to do
Have a Toyota dealer run your VIN for the ball joint recalls. If you hear clunking or the steering feels loose, get the front end inspected before driving at speed, because a separated joint can cause a loss of control.
Typical repair costNo charge if your vehicle is in the recall
Inspect and replace front lower ball joints under recall
Free at a Toyota dealer for trucks covered by the recall. Trucks outside the recall pay for the repair.
Stop soon2002–2007Safety

Passenger airbag inflator can rupture (Takata recall)

What you'll notice
Usually no warning signs at all. The danger only shows up in a crash, when the passenger front airbag deploys.
Why it happens
These trucks used Takata passenger airbag inflators whose propellant breaks down after years of heat and humidity. In a crash the inflator can burst and throw metal fragments into the cabin. Some inflators that were already replaced once were recalled again.
What to do
Ask a Toyota dealer to check your VIN for open recalls today. The replacement is free, and until it is done nobody should ride in the front passenger seat.
Typical repair costNo charge if your vehicle is in the recall
Replace passenger airbag inflator
Get checked2001–2007Exhaust4.7L V8

Cracked exhaust manifold

What you'll notice
A ticking or tapping from the engine on a cold start that often fades as it warms up. You may also smell exhaust or see a check engine light.
Why it happens
The cast iron exhaust manifolds on the 4.7L V8 crack after years of heating and cooling, most often on the driver's side. Exhaust then leaks out of the crack before it reaches the rest of the exhaust.
What to do
Have a shop confirm the leak. A quick check is soapy water sprayed on a cold manifold while the engine starts. Fix it before fumes get into the cabin or the leak throws off the oxygen sensors.
Repair costInsufficient verified pricing for this vehicle and repair
Replace one exhaust manifold and gaskets. Prepare an itemized shop request.
Get checked2001–2007Brakes

ABS and VSC lights from a faulty yaw rate sensor

What you'll notice
The ABS and VSC (stability control) warning lights come on together, sometimes flashing, often with codes C1223 and C1244.
Why it happens
A sensor under the center console that measures how the truck is turning or slowing can fail or be knocked out of position by a bent bracket. With bad readings, the system shuts off ABS and stability control.
What to do
Have the brake system codes read. Normal braking still works, but ABS and stability control may be off until the sensor is replaced or its mounting fixed.
Repair costInsufficient verified pricing for this vehicle and repair
Replace yaw rate (deceleration) sensor. Prepare an itemized shop request.
Walk through this symptom: ABS light on →
Get checked2003Brakes

Stability control can kick in at low speed (recall)

What you'll notice
When pulling away or accelerating at low speed, the stability control engages briefly on its own and the truck feels like it is holding back.
Why it happens
On some 2003 Sequoias the skid control computer did not store the steering angle sensor's center position correctly, so it thought the truck was sliding when it was not.
What to do
Ask a Toyota dealer to check your VIN for this recall. The fix is a free reprogramming.
Typical repair costNo charge if your vehicle is in the recall
Reprogram skid control ECU
Get checked2001–2007Brakes

Front brakes wearing out early

What you'll notice
Front pads wear out much faster than expected, often with grinding, squealing, uneven pad wear or a pull when braking.
Why it happens
The Sequoia is very heavy for its front brakes. In salty areas the caliper slide pins can also rust and seize, so the pads drag and wear unevenly.
What to do
Have the brakes checked at every tire rotation. When replacing pads, make sure the slide pins are cleaned and greased or replaced.
Repair costInsufficient verified pricing for this vehicle and repair
Replace front brake pads (and rotors if worn). Prepare an itemized shop request.
Monitor2001–2004Emissions4.7L V8

Oxygen sensor heater failures

What you'll notice
Check engine light, often with code P0051 or a similar oxygen sensor heater code. Some owners also notice rough idle or lower fuel economy.
Why it happens
The heater circuit inside the oxygen sensors burns out. Early Sequoias are known for repeat oxygen sensor failures.
What to do
Have the code read to see which sensor is at fault, then replace that sensor. Lean codes like P0171 or P0174 point to a different problem and should be diagnosed separately.
Repair costInsufficient verified pricing for this vehicle and repair
Replace one oxygen sensor. Prepare an itemized shop request.
Price guide

Repair prices for your 2003 Toyota Sequoia

Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.

  • Replace one exhaust manifold and gaskets
  • Replace one oxygen sensor
  • Replace yaw rate (deceleration) sensor
  • Replace front brake pads (and rotors if worn)

Recall repairs: usually free at the dealer

A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.

  • Inspect and replace front lower ball joints under recallNo charge if your vehicle is included
  • Replace passenger airbag inflatorNo charge if your vehicle is included
  • Reprogram skid control ECUNo charge if your vehicle is included
Get help with a shop quote →

Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.

Safety recalls for the 2003 Toyota Sequoia
Checking the NHTSA recall database…
Keep a copy of this pageDownload the snapshot, every problem, the repair costs and the recalls for your 2003 Toyota Sequoia as a PDF you can save, print or bring to your shop.
This page is a general guide based on widely reported problems. Not every vehicle is affected, and it doesn't replace an in-person diagnosis.