Your 2010 Volkswagen Routanproblems, repair costs and recalls
What we've documented about the 2010 Volkswagen Routan: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2010 Volkswagen Routan
15 documented issues apply to 2010, most serious first.
Key can slip out of Run and shut the van off (recall)
- What you'll notice
- The engine suddenly shuts off while driving, often after the key ring is bumped or the van hits a bump. Steering and braking get much heavier and the airbags may not work.
- Why it happens
- The ignition switch could be knocked from Run into Accessory or Off. Volkswagen recalled 2009-2010 Routans several times to replace the ignition switch and key fobs.
- What to do
- Ask a Volkswagen dealer to confirm the recall applies to your VIN and have any open recall done for free. Until then, keep the key ring light and don't hang other keys from it.
Power module (TIPM) failure: no-start, stalling or fuel pump that won't shut off
- What you'll notice
- The van cranks but won't start, stalls while driving, or the fuel pump keeps running after the van is off and drains the battery. Some owners also see random warning lights or weak electrical systems.
- Why it happens
- The Routan uses Chrysler's under-hood power module (TIPM). Its built-in fuel pump relay and circuits are known to fail on these minivans.
- What to do
- Have a shop test fuel pump power and the TIPM before replacing the pump, battery or alternator. A repaired or replaced TIPM, or a fix for its fuel pump relay, is usually the cure.
Harsh shifting, stuck in gear or transmission failure
- What you'll notice
- Rough or delayed shifts, harsh downshifts when slowing down, the van stuck in one gear (limp mode), or a transmission that stops shifting altogether.
- Why it happens
- The 6-speed automatic in these vans can wear internally, and its valve body, speed sensors, solenoids and control software are frequent trouble spots. Some cases were improved by a software update.
- What to do
- Check the fluid and have the codes read at the first sign of trouble. Ask about software updates; a sensor or solenoid fix is much cheaper than a full replacement if caught early.
Network (CAN bus) faults cause many warning lights
- What you'll notice
- Several warning lights come on at once, gauges act up, wipers or lights turn on by themselves, or the door locks stop working.
- Why it happens
- Wiring or module faults on the van's data network (CAN bus) stop modules from talking to each other. Tracking the fault down can take a lot of time.
- What to do
- Have a shop scan all modules, not just the engine. Check the battery and grounds first, since low voltage can trigger network faults.
Heater hose Y-pipe and coolant hose leaks
- What you'll notice
- Coolant smell, a sweet-smelling puddle, a low-coolant warning, overheating, or no heat from the vents.
- Why it happens
- The plastic Y-shaped heater hose connectors and rubber coolant hoses on the 3.8L and 4.0L V6 crack and leak with age.
- What to do
- Top up coolant only when the engine is cool and get the leak found quickly. Don't keep driving if the temperature gauge climbs.
Excessive oil consumption
- What you'll notice
- The oil level drops between changes, the low oil light comes on, or blue smoke appears from the tailpipe.
- Why it happens
- Some 3.8L and 4.0L engines burn oil, likely from worn piston rings or valve seals. Dealers often call moderate oil use normal.
- What to do
- Check the oil every fill-up and keep it full. Document the usage; if it is heavy, a compression and leak-down test will show what is worn.
Power sliding door hinge breaks or door sticks
- What you'll notice
- A sliding door grinds, sticks, won't close on its own, reverses while closing, or rubs the body paint. Some doors hang loose from a broken hinge.
- Why it happens
- The lower hinge and roller track wear and break, and the door module can be overly sensitive. Volkswagen issued fixes including hinge replacement and reprogramming.
- What to do
- Have the hinge, track and door module checked. Lubricating the track helps, but a broken hinge should be replaced before it damages the door.
Brakes wear out early and rotors warp
- What you'll notice
- Steering wheel shake or pedal pulsing when braking, squealing, and pads that need replacing much sooner than expected.
- Why it happens
- The brakes on these heavy vans run hot and the rotors warp easily, which also wears pads quickly.
- What to do
- Have pads and rotors measured. Quality rotors and pads, and not riding the brakes on hills, help them last longer.
Sticking brake calipers
- What you'll notice
- The van pulls to one side, one wheel gets very hot, a grinding noise from one corner, or brake pads that wear unevenly.
- Why it happens
- Caliper pistons and slide pins corrode and stick, so a brake keeps dragging. Rear calipers and the parking brake cable are often involved.
- What to do
- Have the brakes inspected soon; a dragging caliper ruins pads and rotors and can overheat the brakes.
A/C blows warm from leaks or compressor failure
- What you'll notice
- The A/C blows warm, especially from the rear vents, or works only now and then.
- Why it happens
- Refrigerant leaks at the rear A/C lines and rear evaporator are common on these vans, and compressors fail too.
- What to do
- Have the system leak-tested with dye before recharging. Recharging without fixing the leak just wastes money.
Worn wheel bearings
- What you'll notice
- A humming or growling noise that gets louder with speed and may change when turning.
- Why it happens
- Front and rear wheel bearings wear out on these heavy vans. A Chrysler bulletin covered front bearings on some vans.
- What to do
- Have the bearings checked. A badly worn bearing can overheat and become unsafe, so don't put it off.
Power steering leaks and pump noise
- What you'll notice
- Whining from the engine bay when turning, heavier steering, or power steering fluid leaking.
- Why it happens
- The power steering pump bearing and return hoses on these vans can wear and leak.
- What to do
- Check the fluid level and look for leaks. A noisy pump that keeps losing fluid should be fixed before it fails.
Tire pressure sensors fail or light flickers
- What you'll notice
- The tire pressure light comes on or flickers even when tires are fine, or a sensor stops reading.
- Why it happens
- The tire pressure sensors corrode at the valve stems and their batteries wear out with age.
- What to do
- Check the tires with a gauge first. Failed sensors can be replaced one at a time and need to be relearned.
Sunroof and liftgate water leaks
- What you'll notice
- Water inside the cabin, wet headliner or damp cargo area after rain.
- Why it happens
- Sunroof seals and the liftgate's upper seal can leak, and clogged drains make it worse.
- What to do
- Clear the sunroof drains and check the seals. A body shop can reseal the liftgate gasket.
Radio and Bluetooth freezing or distortion
- What you'll notice
- The radio freezes, rejects Bluetooth, or distorts sound when playing from an iPod.
- Why it happens
- Software faults in the factory radio; an update fixed many units.
- What to do
- Ask a dealer for any radio software update before replacing the unit.
Repair prices for your 2010 Volkswagen Routan
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace or repair TIPM power module
- Repair valve body/sensors or replace automatic transmission
- Replace heater hose Y-pipe/coolant hoses
- Compression/leak-down test and diagnosis
- Replace sliding door lower hinge/track or door motor
- Front brake pads and rotors
- Replace brake caliper
- Diagnose and repair CAN bus wiring or module
- Repair refrigerant leak or replace A/C compressor
- Replace wheel bearing/hub assembly (one wheel)
- Replace TPMS sensor and relearn
- Replace power steering pump or return hose
- Clear drains and reseal sunroof or liftgate
- Radio software update
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Ignition switch and key fob recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…