Home › Warning lights › Diesel particulate filter light
Amber/yellow: check soon

Diesel particulate filter light

Also called: DPF light

How urgent? Get it checked soon

What it means

The diesel particulate filter is filling with soot and needs to clean itself (regenerate).

An amber light in the main instrument cluster, usually drawn as a box or canister shape with dots or specks inside it and a short exhaust pipe at each end. Some makes use a different picture, such as an exhaust pipe with dots puffing out of it, and many newer vehicles skip the symbol and put a message on the screen instead, like Diesel Particulate Filter Full or Exhaust Filter Nearly Full Drive to Clean.

Can I keep driving?

Yes. A 20-minute drive at steady highway speed usually lets it clean itself. If it stays on, get it checked before it clogs.

If it's flashing or blinking: On several makes a flashing or blinking filter light, or the same light paired with a check engine light, means the filter is badly blocked and the vehicle can no longer clean it by itself. At that point driving on the highway will not fix it and you need a shop before the engine goes into reduced power.

What to do now

  1. Take a steady 20-minute highway drive.
  2. If it won't clear, have a shop force a regeneration.

Common causes

  • Lots of short trips
  • Faulty pressure sensor
  • Engine problems making extra soot

Checks you can do yourself

Safe, no tools in most cases

Do these with the car parked and the engine off and cool. If anything looks or smells hot, wait.

1
Take a steady highway drive to let it clean itself

This light often just means the filter needs a hot run to burn off its soot. Get the engine fully warmed up, then drive at a steady highway speed for twenty to thirty minutes without stopping, in a lower gear than normal if you can, so the engine turns a bit faster. Do not switch the engine off partway. If the light goes out during or shortly after the drive, that is exactly what was supposed to happen.

30 minutes · None
2
Check you have enough fuel first

The cleaning cycle burns extra fuel, so most diesels refuse to start one when the tank is low, often below about a quarter full. Look at the fuel gauge before you set off and fill up if it is anywhere near the bottom. A full tank is the simplest reason a long drive sometimes fails to clear the light.

2 minutes · None
3
Check the engine oil level and when it was last changed

With the engine off and cool and the vehicle on level ground, pull the dipstick, wipe it, push it fully back in and read it. The cleaning cycle puts a little diesel into the oil, so oil that is overfull, thin, diesel smelling or long overdue will block the cycle. If the oil is overdue or the level is above the top mark, book an oil change with the correct low ash diesel oil.

5 minutes · A rag
4
Note every other light that is on with it

The vehicle will not run a cleaning cycle while certain other faults are stored, so the filter light with company tells a very different story to the filter light on its own. Write down whether the check engine light, glow plug light, coolant temperature warning or reduced power message is also showing, and tell the shop. That list often points straight at the real cause.

3 minutes · None
5
Watch the temperature gauge on your next drive

A diesel that never gets properly warm cannot clean its filter. On your next normal drive, watch whether the coolant temperature gauge climbs to its usual middle position within about ten minutes and stays there. If it sits low or drifts back down on the highway, mention it: a stuck thermostat is a common hidden reason the filter keeps filling up.

10 minutes · None

Step-by-step repair walkthroughs for the fixes below are on the way.

What not to do

  • Don't shut the engine off in the middle of a cleaning cycle if you can avoid it. Interrupted cycles are a main reason the filter never finishes cleaning.
  • Don't just carry on with short cold trips and hope. Every short trip adds soot the engine never gets hot enough to burn off.
  • Don't ignore the light until the engine goes into reduced power. Driving to clean the filter is cheap; a blocked filter is one of the most expensive repairs on a diesel.
  • Don't have the filter gutted, drilled or 'deleted'. It is illegal on a road vehicle, it fails emissions testing and it destroys the resale value.

What it usually turns out to be

Most likely first. Prices are typical US parts-and-labor totals for that repair, not a quote for your vehicle.

Too many short, cold trips, so the filter never cleaned itselfPrice not verified

How you can tell The vehicle is used for school runs, town errands and a short commute, the light came on with no other warnings, and a scan shows the soot level high but nothing broken. This is the ordinary, nothing is wrong reason, and it is the most common one.

The repair A long steady highway drive, which costs nothing but fuel. If the soot level is already too high for the vehicle to clean itself, a shop starts a cleaning cycle with a scan tool.

Faulty pressure sensor or its hosesPrice not verified

How you can tell The light comes and goes, or it comes back soon after a good highway run, and a scan stores a code about the filter pressure sensor or filter restriction. The small hoses that feed the sensor can also be cracked, soot blocked or pushed off, which makes the vehicle read a blockage that is not there.

The repair The sensor or its hoses are replaced and the stored fault cleared. It is a cheap part and a quick job compared with anything else on this list.

Exhaust temperature sensor fault blocking the cleaning cyclePrice not verified

How you can tell The filter light stays on and the vehicle never starts a cleaning cycle at all, however far you drive, and a scan shows an exhaust gas temperature sensor code. These sensors have to agree before the computer will let the cycle run.

The repair The faulty temperature sensor is replaced. The sensors sit in hot exhaust and can be seized in, which is what pushes the labor time up.

An engine fault making far too much sootPrice not verified

How you can tell The filter light keeps returning after it has been cleaned, often with a check engine light, black smoke, poor economy or a rough idle. Worn or leaking fuel injectors, a stuck exhaust gas recirculation valve or a tired turbo all fill the filter faster than the vehicle can empty it.

The repair The shop finds and repairs the engine fault first, then cleans or replaces the filter. Fixing the filter without fixing the cause just means doing it again.

Filter is blocked with ash and needs cleaning or replacementPrice not verified

How you can tell High mileage, a scan showing the filter near its limit or a failed cleaning cycle, and usually reduced engine power. Ash is the leftover that burning soot cannot remove, so it builds up over the life of the filter and eventually fills it for good.

The repair The filter comes off and goes into a cleaning oven where heat and pressure strip the ash, or it is replaced. Many car filters are welded into the exhaust, so a dealer will often only offer replacement.

What a shop will do

A shop plugs in a scan tool and looks at the real numbers first: how full of soot the filter is, the pressure sensor reading, how far you have driven since the last cleaning cycle, and whether any other fault is blocking a cycle. If the filter is not too far gone they start a cleaning cycle themselves, either parked or on a road test, and watch the exhaust temperature climb. Reading the data and deciding takes under an hour; the cleaning cycle itself adds roughly thirty to forty five minutes of running.

How to reset this light

This light is meant to go out by itself once the filter has been cleaned, either by a long hot drive or by a cleaning cycle a shop starts with a scan tool. If a shop cleans or replaces the filter, part of the job is resetting the soot and ash counters so the vehicle starts counting from zero again. What does not work is clearing the code to make the light go away: the filter is still full, the vehicle measures it again within a few miles and the light comes straight back, usually with more soot in there than before.

How full the filter can get before the vehicle refuses to clean it on its own, and whether a parked cleaning cycle is even allowed, differ by make and model.

Coming soon

Reset steps for your exact vehicle

We're building the button-by-button reset for each year, make and model. Tell us what you drive and it will be here when it's ready.

Pick my vehicle

Trouble codes often stored with this light

Common questions

What does the diesel particulate filter light mean?

The diesel particulate filter is filling with soot and needs to clean itself (regenerate).

Can I drive with the diesel particulate filter light on?

Yes. A 20-minute drive at steady highway speed usually lets it clean itself. If it stays on, get it checked before it clogs.

How long can I drive with the DPF light on?

If it is the only light on, you can drive, and driving is actually the fix. Deal with it in the next day or two rather than the next month. Keep going on short trips for weeks and the filter fills past the point where the vehicle can clean itself, and then it turns into a repair bill instead of a drive.

What speed and how long do I need to drive to clear it?

Get the engine fully warm, then hold a steady highway speed, roughly fifty to sixty five miles an hour, for twenty to thirty minutes without stopping. Using a lower gear so the engine turns faster helps it get hot enough. If two of those drives do nothing, stop trying and have it scanned.

The light went out on its own. Was something wrong?

Probably not. Going out on its own means the cleaning cycle finished, which is the system working as designed. If it keeps coming back every few hundred miles, though, that is a sign something is filling the filter faster than normal and it is worth a scan.

Will my car pass inspection with the DPF light on?

In a state with an emissions test, no. The test reads the vehicle's own self checks, and a lit filter warning or a stored filter fault is a fail. If a good highway drive clears the light and no fault stays stored, it can pass, but a vehicle that needs the filter cleaned or replaced has to be fixed first.

Do those DPF cleaner bottles you pour in the tank work?

They can help a filter that is only mildly loaded, mostly by helping the soot burn at a lower temperature, so they are worth a try alongside a highway drive. They will not unblock a filter that is already full or packed with ash, and they do nothing at all for a bad sensor or an engine fault.

Sources: Jalopnik · FenderBender

Not your light? These get mixed up with it

Symbols vary a little between makes. Your owner's manual shows the exact lights for your vehicle. This is a general guide, not a diagnosis.