Home › Warning lights › Exhaust emission system light
Amber/yellow: check soon

Exhaust emission system light

Also called: Exhaust system light, Emission system warning light, Exhaust gas warning light, EML

How urgent? Get it checked soon

What it means

Something in the exhaust or emissions system is not doing its job. On many European and some Asian cars this is a separate warning from the check engine light, so the car can tell you the trouble is in the exhaust.

It lives in the main instrument cluster and is always amber or yellow. Most European makes draw a small engine block seen from the side with two or three curls of exhaust gas trailing off it; others use a short exhaust pipe with puffs of smoke. Several Asian makes draw nothing and simply write EMISSION SYSTEM or CHECK EXHAUST in the message screen.

Can I keep driving?

Usually yes, gently, for a week or two while you book it in, as long as the light is steady and the car feels normal. If it is flashing, or the car has dropped into reduced power, drive straight to a shop: a flashing light means the engine is misfiring and raw fuel is cooking the catalytic converter.

If it's flashing or blinking: A flashing exhaust light means the engine is misfiring right now and unburned fuel is pouring into the catalytic converter, which can wreck it within a few miles. Ease off the accelerator, keep your speed down, and get it seen the same day.

What to do now

  1. Notice whether the light is steady or flashing, and whether the car has lost power.
  2. Get the codes read. Many parts stores do it free, and the code number points straight at the part.
  3. Book the repair rather than waiting. A cheap sensor left alone often takes the catalytic converter with it.
  4. On a diesel, check the exhaust fluid level, because low or wrong DEF sets this warning too.

Common causes

  • Oxygen (lambda) sensor
  • Exhaust leak or loose clamp ahead of a sensor
  • EGR valve clogged with soot
  • NOx sensor on a diesel
  • Worn out catalytic converter
  • Misfire from spark plugs or ignition coils

Checks you can do yourself

Safe, no tools in most cases

Do these with the car parked and the engine off and cool. If anything looks or smells hot, wait.

1
Tighten the fuel cap and check its seal

A loose or cracked fuel cap lets fuel vapour escape and sets emissions faults on a lot of cars. Open the fuel door, take the cap off, and put it back on until it clicks. Look at the rubber ring for cracks or grit while it is in your hand. If that was the cause, the light often goes out on its own after a few drives.

2 minutes · None
2
Get the trouble code read

Drive to a parts store that reads codes free, or plug a cheap code reader into the socket under the dash. Write down every number it reports, P0420 and the rest. Those numbers tell a shop which part of the exhaust is complaining, and they save you paying someone else to find out what you could have found out for nothing.

15 minutes · None, or a basic code reader
3
Check the exhaust fluid level on a diesel

If your diesel has a second, usually blue, filler cap next to the fuel filler, it uses exhaust fluid. Look at the dash readout for the level. Low fluid, or the wrong fluid in the tank, sets exhaust warnings on its own. Topping up from a sealed bottle of DEF or AdBlue is a job you can do standing at the filler.

10 minutes · A sealed bottle of DEF or AdBlue
4
Listen for an exhaust leak

With the car parked in park or neutral and the handbrake on, start it from cold and stand a few steps away from the front wheel. A ticking or puffing noise from beneath the front of the car often means a cracked pipe or a loose clamp, and air getting in there upsets the sensors. Do not touch any part of the exhaust: it is hot within a minute of starting.

5 minutes · None
5
Look at the tailpipe smoke

Start the car from cold and glance at the tailpipe from a few steps back. Thin white vapour on a cold morning is normal and clears as the engine warms. Thick black, blue, or sweet-smelling white smoke that does not clear is worth telling the shop about, because it narrows things down before the clock starts on diagnosis.

3 minutes · None

Step-by-step repair walkthroughs for the fixes below are on the way.

What not to do

  • Don't keep driving hard with the light flashing. A few miles of misfire can destroy a catalytic converter.
  • Don't clear the code and head straight to an emissions test. The car has to re-run its own self-checks and will fail as not ready.
  • Don't let a cheap sensor fault sit for months. It very often takes the catalytic converter with it.
  • Don't assume it means the same as the check engine light on a European car. They are different warnings and both sets of codes need reading.

What it usually turns out to be

Most likely first. Prices are typical US parts-and-labor totals for that repair, not a quote for your vehicle.

Oxygen (lambda) sensorPrice not verified

How you can tell The commonest cause. Fuel economy slips, the idle can be slightly rough, and the stored code names a sensor by bank and position. A shop compares the sensor's live reading with what the engine is actually doing to prove it is lying.

The repair Replace the sensor that has failed. A car has two or four of them and only the bad one gets changed.

Exhaust leak or loose clamp ahead of a sensorPrice not verified

How you can tell A ticking or puffing noise from the front of the exhaust, often loudest when cold. The extra air fools the sensors into reporting a lean mixture, so the car sets an emissions fault with nothing wrong with the sensor itself.

The repair Weld or replace the cracked section, or fit a new flange gasket and clamp.

EGR valve clogged with sootPrice not verified

How you can tell More common on diesels and turbocharged gas engines. Rough idle, hesitation pulling away, and a code about EGR flow. A shop can watch the valve stick part open or part shut on a scan tool.

The repair Clean or replace the EGR valve, and the cooler behind it if that is blocked too.

NOx sensor on a dieselPrice not verified

How you can tell Modern diesels only. The car often drops into reduced power and may warn that restarts will be blocked after so many miles. The code names the NOx sensor before or after the catalyst. These fail fairly often on European diesels.

The repair Replace the sensor. On many cars the new one has to be coded to the engine computer afterwards.

Worn out catalytic converterPrice not verified

How you can tell Usually follows months of an ignored sensor fault or misfire. A faint rotten-egg smell, sluggish acceleration, and the classic catalyst efficiency code P0420. A shop proves it by comparing the readings either side of the converter.

The repair Replace the converter, and fix whatever killed it first, or the new one dies the same way.

Misfire from spark plugs or ignition coilsPrice not verified

How you can tell This is the flashing version of the light. The car shakes at idle, feels down on power, and the code names a cylinder. A shop swaps a coil to another cylinder to see whether the misfire follows it.

The repair Replace the failed coil or the spark plugs, usually as a full set.

What a shop will do

The shop plugs in a scan tool first and reads the stored codes along with the snapshot of data the car saved when the fault happened. Then it watches the oxygen and NOx sensor readings live with the engine running, checks how far the computer is trimming the fuel, and often smoke-tests the exhaust and intake for leaks before touching a single part. On a diesel they also look at the exhaust fluid, the EGR valve and the particulate filter. Expect about an hour of diagnosis, longer if the fault only shows up out on the road.

How to reset this light

This is a fault light, not a service reminder, so there is nothing to reset. A scan tool will switch it off, but it comes back within a few drives until the real fault is repaired. Once the part is actually fixed the light goes out on its own, after the car has re-run its own emissions self-checks. That can take a few days of mixed driving rather than one trip round the block.

Some makes will not clear the light until the car has completed a full drive cycle, which usually means a cold start plus some highway miles.

Common questions

What does the exhaust emission system light mean?

Something in the exhaust or emissions system is not doing its job. On many European and some Asian cars this is a separate warning from the check engine light, so the car can tell you the trouble is in the exhaust.

Can I drive with the exhaust emission system light on?

Usually yes, gently, for a week or two while you book it in, as long as the light is steady and the car feels normal. If it is flashing, or the car has dropped into reduced power, drive straight to a shop: a flashing light means the engine is misfiring and raw fuel is cooking the catalytic converter.

Is this the same as the check engine light?

On most American and Japanese cars, yes, because the check engine light covers emissions faults. Many European cars and a few Asian ones give the exhaust its own amber light so they can point you at the exhaust rather than the whole engine. If both are lit, have both sets of codes read.

Will my car pass an emissions test with this light on?

In most states that test, no. An emissions warning lit at the time of the test fails the plug-in part of the test whatever the tailpipe reads. Clearing the code on the way there does not help either, because the test also checks that the car has finished its own self-checks.

How long can I drive with the exhaust emission light on?

If it is steady and the car feels normal, a week or two of ordinary driving while you book it in is reasonable. If it is flashing, or the car has lost power, that is a same-day problem. A sensor fault ignored for months often ends up costing you a catalytic converter too.

Why has the car suddenly lost power?

Modern cars deliberately cut power when the exhaust reports a fault, to protect the catalytic converter or the particulate filter. It is called limp or reduced power mode. It is not damage in itself, and full power comes back once the fault is repaired.

Does the light reset itself?

After a genuine repair, yes. The car runs its emissions self-checks over the next few trips and switches the light off when they pass, which can take a few days of mixed driving. If nothing has been repaired, it will come back every time.

Sources: Volkswagen · RepairPal

Not your light? These get mixed up with it

Symbols vary a little between makes. Your owner's manual shows the exact lights for your vehicle. This is a general guide, not a diagnosis.