Check engine light
Also called: Service engine soon, Engine malfunction light, MIL
What it means
The engine computer found a problem with the engine, fuel, ignition or emissions system and stored a trouble code.
It sits in the main instrument cluster, usually near the middle, and is shaped like the side view of an engine block with small bumps along the top. It is almost always amber or yellow. Some makes skip the symbol and print the words SERVICE ENGINE SOON, CHECK ENGINE or ENGINE in the display, and a few show a plain outline of an engine with a lightning bolt or an exclamation mark inside it.
Can I keep driving?
If it's flashing or the engine is shaking hard, pull over when it's safe and turn the engine off; a flashing light means a misfire that can ruin the catalytic converter. If it's steady and the car drives normally, you can usually drive gently and get it checked soon.
If it's flashing or blinking: A flashing or blinking check engine light is more serious than a steady one. It means the engine is misfiring badly and unburned fuel is passing into the exhaust, which can overheat and ruin the catalytic converter in a matter of minutes. Ease off the gas, avoid towing or high speeds, drive only as far as you need to get somewhere safe, and have it looked at the same day.
What to do now
- Check that the gas cap is tight (a loose cap is a common cause).
- Notice how the car drives: rough idle, shaking or loss of power make it more urgent.
- Get the code read. Many parts stores do it free, then look the code up on our Code lookup.
Common causes
- Loose or damaged gas cap
- Oxygen sensor or catalytic converter
- Misfire from spark plugs or ignition coils
- Mass airflow sensor
- Evaporative (EVAP) leak
Checks you can do yourself
Safe, no tools in most casesDo these with the car parked and the engine off and cool. If anything looks or smells hot, wait.
With the engine off, unscrew the fuel cap and screw it back on until it clicks at least once. Look at the rubber seal around the edge: if it is cracked, hard or missing, the cap is not sealing and needs replacing. A loose or worn cap is one of the most common reasons this light comes on, and the light may take a few days of normal driving to go out on its own.
2 minutes · NoneThe engine computer stored a code that says which system it is unhappy about. Many chain parts stores will read it free in the parking lot in a couple of minutes, or you can plug in a cheap code reader yourself at the socket beneath the dash on the driver's side. Write the code down exactly, letter and all four digits, then look it up on our code lookup before you agree to any repair.
10 minutes · None, or a basic code readerBefore you call anyone, make a short list of what the car is doing. Is the idle rough or shaky, is there a smell of fuel or rotten eggs, does it hesitate when you press the gas, is it using more fuel than usual, does it only happen when cold or when the air conditioning is on? A shop can get to the real fault far faster with that list, which keeps your diagnosis time down.
5 minutes · NoneWith the engine off and cool, open the hood and look across the top of the engine for a rubber air hose that has popped off, a plastic connector hanging loose, or an air filter box lid that is not clipped down. Push anything like that back on by hand until it seats. Do not pull wires apart to inspect them, and leave anything hot, pressurised or hidden from view for a shop.
5 minutes · NoneStep-by-step repair walkthroughs for the fixes below are on the way.
What not to do
- Don't keep driving hard, carrying a heavy load or towing while the light is flashing; you can melt the catalytic converter and turn a modest repair into a very expensive one.
- Don't disconnect the battery to make the light go away. The fault comes straight back and you wipe out the stored code a shop needs to find it.
- Don't let a steady light sit for months. A cheap sensor or small misfire left alone is what kills catalytic converters.
- Don't book an emissions test with the light on. In most states a lit check engine light is an automatic fail, test fee included.
What it usually turns out to be
Most likely first. Prices are typical US parts-and-labor totals for that repair, not a quote for your vehicle.
How you can tell No change in how the car drives, and often it appears a day or two after filling up. The stored code is usually one of the evaporative emissions leak codes such as P0455 or P0442. The cap may feel loose or its rubber seal may look dry and cracked.
The repair Tighten the cap, or fit a new one if the seal is damaged. If a new cap does not fix it, a shop smoke-tests the fuel tank and vent lines for a leaking hose or valve.
How you can tell Fuel economy slips, the idle may be slightly uneven, and the exhaust can smell richer than normal. Codes usually point at a sensor circuit or a fuel mixture that is too rich or too lean, such as P0171. The car often still drives fine, which is why people put this one off.
The repair The faulty sensor is unscrewed from the exhaust and a new one fitted. Cost depends mostly on which of the two to four sensors it is and how hard it is to reach.
How you can tell The engine shakes at idle, stumbles when you accelerate, and may lose noticeable power. This is the usual cause when the light is flashing. Codes are in the misfire family, P0300 for a random misfire or P0301 through P0308 for a named cylinder.
The repair The failed coil is replaced and the spark plugs are usually renewed as a set at the same time, since worn plugs are what kill coils.
How you can tell Hesitation when pulling away, surging idle, sometimes a stall just after start-up, and worse fuel economy. The code names the mass airflow circuit or an air and fuel mixture that is out of range. A dirty air filter or a split intake hose often sits behind it.
The repair The sensor is cleaned or replaced and the air filter and intake hoses are checked, since a split hose will cause the same symptom again.
How you can tell Usually no symptoms at all, though some cars idle oddly or are hard to restart straight after refuelling. The code points at the purge or vent valve circuit or at a leak the smoke test traces to the valve rather than the cap.
The repair The stuck valve is replaced. It is a small part bolted to the engine bay or near the fuel tank, and the work is typically under an hour.
How you can tell Often no driving symptoms early on, then sluggish acceleration and a sulphur or rotten egg smell. The classic code is P0420 or P0430. A converter rarely dies on its own, so a shop should also find what killed it, usually a long-running misfire or oil burning.
The repair The converter section of the exhaust is replaced, and the underlying cause is repaired first so the new one is not destroyed too.
What a shop will do
A shop plugs a scan tool into the socket beneath the dash, pulls every stored code plus the freeze frame data that shows what the engine was doing the moment the fault was recorded, then clears nothing and goes looking. From there it is live data, a smoke test for an evaporative leak, or a cylinder and ignition test for a misfire. Expect roughly half an hour for a simple one and up to two hours for an intermittent fault that has to be reproduced on a test drive.
How to reset this light
This is a fault light, not a service reminder, so there is nothing you are meant to reset. A code reader or a battery disconnect will switch the light off for a while, but it has repaired nothing: the engine computer runs the same self-test again over the next few drives and the light comes back as soon as it sees the fault. Clearing it also wipes the stored code and the freeze frame data, which makes the job harder and the diagnosis more expensive. The one exception is a genuine fix such as tightening a loose gas cap, after which the light often goes out by itself within a few days of normal driving.
Clearing codes also resets the emissions readiness monitors, and most states will not pass the car until those have reset themselves over several days of mixed driving.
Walk through it step by step
Trouble codes often stored with this light
Common questions
What does the check engine light mean?
The engine computer found a problem with the engine, fuel, ignition or emissions system and stored a trouble code.
Can I drive with the check engine light on?
If it's flashing or the engine is shaking hard, pull over when it's safe and turn the engine off; a flashing light means a misfire that can ruin the catalytic converter. If it's steady and the car drives normally, you can usually drive gently and get it checked soon.
How long can I drive with the check engine light on?
If it is flashing, or the car is shaking, losing power or smells of fuel, pull over when it's safe and turn the engine off. If the light is steady and the car drives, idles and sounds normal, you can usually finish your trip and book a scan within the next week or so.
Will my car pass inspection with the check engine light on?
In most states, no. An emissions or safety inspection that reads the engine computer fails the car automatically when the light is lit, whatever the reason. Fix the fault first, then drive the car for several days so the computer finishes its self-tests before you book the test.
Does the check engine light reset itself?
Sometimes. If the fault was something that truly went away, such as a gas cap you tightened, the computer needs to pass the same self-test a few times before it turns the light off, which usually takes two or three days of ordinary driving. If the fault is still there, the light stays on.
Is it safe to drive at night with the check engine light on?
The light itself has nothing to do with your lights, brakes or steering, so night driving is no more risky than daytime driving with it on. The real question is how the car is running. If it is misfiring or losing power, being stranded on a dark road is the danger, so get it sorted before a long night trip.
Why is my check engine light on with no symptoms?
That is very common and usually good news. Evaporative emissions faults, a slightly lazy oxygen sensor and a stuck purge valve all trigger the light while the car drives perfectly. It still needs reading, because the computer only has one light for problems that cost a little and problems that cost a lot.
Sources: Car Pro · Vehicle Service Pros · Cars Commerce