P0300 Random/Multiple Cylinder Misfire Detected
What it means
The computer is seeing misfires in more than one cylinder, or in cylinders that keep changing. If the check engine light is flashing, ease off and stop driving soon, because a heavy misfire can overheat and ruin the catalytic converter.
Can I keep driving?
If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.
Otherwise: If the check engine light is flashing or the engine shakes hard, slow down and get it checked right away; a heavy misfire can overheat and ruin the catalytic converter. If the light is steady and it runs only a little rough, drive gently to a shop within a few days.
What to test before replacing parts
Look for other codes, then check plugs, coils, vacuum leaks and fuel pressure, and compression or timing if needed. Random misfires often share one cause, so find it before replacing parts.
- Look for other codes (lean codes, single-cylinder misfire codes) that point to the real cause
- Check when the spark plugs were last replaced and inspect them
- Listen and check for vacuum leaks, and check fuel pressure
Signs you may notice
- Check engine light on, and it may flash during a heavy misfire
- Rough or shaky idle
- Stumbling, jerking or loss of power when accelerating
- Worse fuel economy and possibly a fuel or rotten-egg smell
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWorn-out spark plugs
- CommonVacuum leak from a cracked hose or intake gasket
- CommonWeak or failing ignition coils or plug wires
- PossibleLow fuel pressure from a weak pump or clogged filter
- PossibleDirty mass airflow sensor or other lean condition
- PossibleBad gas, low compression or a jumped timing belt or chain
Typical repair once the cause is confirmed
Most often a set of spark plugs (and any weak coils); if that doesn't cure it, the shop moves on to vacuum leaks, fuel pressure and compression.
Where it shows up
- Very common on high-mileage engines still running old or original spark plugs
- Cracked intake or PCV hoses on older trucks and SUVs often trigger it
Known on these vehicles
Common questions
What does P0300 mean?
The computer is seeing misfires in more than one cylinder, or in cylinders that keep changing. If the check engine light is flashing, ease off and stop driving soon, because a heavy misfire can overheat and ruin the catalytic converter.
Can I drive with code P0300?
If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light is flashing or the engine shakes hard, slow down and get it checked right away; a heavy misfire can overheat and ruin the catalytic converter. If the light is steady and it runs only a little rough, drive gently to a shop within a few days.
What causes P0300?
Common possibilities to test include: worn-out spark plugs; vacuum leak from a cracked hose or intake gasket; weak or failing ignition coils or plug wires; low fuel pressure from a weak pump or clogged filter. A shop should confirm the cause before replacing parts.