Home › Code lookup › P0301
Powertrain code · Ignition

P0301 Cylinder 1 Misfire Detected

How urgent? Otherwise: Get it checked in the next few days

What it means

The computer noticed that cylinder 1 isn't firing properly, so it isn't adding its share of power. If the check engine light is flashing, ease off and stop driving soon, because unburned fuel can overheat the catalytic converter.

Can I keep driving?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.

Otherwise: If the check engine light flashes or the engine shakes badly, ease off and get it checked right away; unburned fuel from a misfiring cylinder can overheat the catalytic converter. If the light is steady and it runs mostly smooth, drive gently to a shop within a few days.

What to test before replacing parts

Inspect cylinder 1's plug, swap its coil with a neighbor to see if the misfire follows, check its injector, and run a compression test if those check out, before replacing parts.

  1. Pull the spark plug for that cylinder and look for wear, oil or carbon
  2. Swap the coil with a neighboring cylinder and see if the misfire moves with it
  3. Run a compression test if plugs and coils check out

Signs you may notice

  • Check engine light on, and it may flash while the misfire is happening
  • Rough or shaky idle
  • Hesitation or stumble when accelerating
  • Less power and worse fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWorn or fouled spark plug in cylinder 1
  • CommonFailing ignition coil or plug wire for cylinder 1
  • PossibleClogged or leaking fuel injector for cylinder 1
  • PossibleVacuum leak near that cylinder's intake port
  • PossibleLow compression from a burnt valve, worn rings or head gasket problem

Typical repair once the cause is confirmed

Usually a new spark plug and/or ignition coil for that cylinder; if the misfire stays put after those, check the injector and compression.

Repair costInsufficient verified pricing for this vehicle and repair
Replace spark plug and ignition coil (one cylinder). Prepare an itemized shop request.

Known on these vehicles

Walk through it step by step: Engine sputters or misfires →

Common questions

What does P0301 mean?

The computer noticed that cylinder 1 isn't firing properly, so it isn't adding its share of power. If the check engine light is flashing, ease off and stop driving soon, because unburned fuel can overheat the catalytic converter.

Can I drive with code P0301?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light flashes or the engine shakes badly, ease off and get it checked right away; unburned fuel from a misfiring cylinder can overheat the catalytic converter. If the light is steady and it runs mostly smooth, drive gently to a shop within a few days.

What causes P0301?

Common possibilities to test include: worn or fouled spark plug in cylinder 1; failing ignition coil or plug wire for cylinder 1; clogged or leaking fuel injector for cylinder 1; vacuum leak near that cylinder's intake port. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.