Home › Code lookup › P0312
Powertrain code · Ignition

P0312 Cylinder 12 Misfire Detected

How urgent? Otherwise: Get it checked in the next few days

What it means

The computer noticed that cylinder 12 isn't firing properly, so it isn't adding its share of power. If the check engine light is flashing, ease off and stop driving soon, because unburned fuel can overheat the catalytic converter.

Can I keep driving?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.

Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Pull the spark plug for that cylinder and look for wear, oil or carbon
  2. Swap the coil with a neighboring cylinder and see if the misfire moves with it
  3. Run a compression test if plugs and coils check out
  4. On V6 and V8 engines, rear-bank plugs and coils may sit under the intake plenum, which adds labor

Signs you may notice

  • Check engine light on, and it may flash while the misfire is happening
  • Rough or shaky idle
  • Hesitation or stumble when accelerating

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWorn or fouled spark plug in cylinder 12
  • CommonFailing ignition coil or plug wire for cylinder 12
  • PossibleClogged or leaking fuel injector for cylinder 12
  • PossibleVacuum leak near that cylinder's intake port
  • PossibleLow compression from a burnt valve, worn rings or head gasket problem

Typical repair once the cause is confirmed

Usually a new spark plug and/or ignition coil for that cylinder; if the misfire stays put after those, check the injector and compression.

Walk through it step by step: Engine sputters or misfires →

Common questions

What does P0312 mean?

The computer noticed that cylinder 12 isn't firing properly, so it isn't adding its share of power. If the check engine light is flashing, ease off and stop driving soon, because unburned fuel can overheat the catalytic converter.

Can I drive with code P0312?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0312?

Common possibilities to test include: worn or fouled spark plug in cylinder 12; failing ignition coil or plug wire for cylinder 12; clogged or leaking fuel injector for cylinder 12; vacuum leak near that cylinder's intake port. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.