Home › Warning lights › Engine temperature warning light
Red: serious, act now

Engine temperature warning light

Also called: Coolant temperature light, Overheating light, Thermometer light

How urgent? Stop driving as soon as it's safe

What it means

The engine is overheating, or the coolant level is too low. If it's blue, the engine is just still cold.

It sits in the main instrument cluster and looks like a thermometer dipped in liquid, with wavy lines under it. Red means too hot; on many cars the same symbol glows blue for a minute after a cold start, which only means the engine is still warming up. Some makes show words instead, such as ENGINE HOT or COOLANT TEMP, and some just swing the temperature needle into the red band.

Can I keep driving?

Not if it's red. Pull over, turn the engine off and let it cool. Driving an overheating engine can warp the cylinder head or blow the head gasket.

If it's flashing or blinking: On a number of European cars the coolant symbol blinks when the coolant level in the tank has dropped, and glows steady when the engine is actually too hot. Treat a blinking one as low coolant and a steady red one as overheating, and check your owner's manual, because makes differ.

What to do now

  1. If you can't stop yet, turn the A/C off and the heater on full hot to pull heat away.
  2. Pull over and turn the engine off.
  3. Never open the radiator cap while hot. Once cool, check the coolant level and look for leaks.

Common causes

  • Low coolant from a leak
  • Cooling fan not working
  • Failed thermostat or water pump
  • Head gasket failure

Checks you can do yourself

Safe, no tools in most cases

Do these with the car parked and the engine off and cool. If anything looks or smells hot, wait.

1
Let it cool, then check the coolant tank level

Wait at least half an hour after shutting the engine off, until the hood is cool to the touch. Find the translucent plastic coolant tank in the engine bay and look at the level against the MIN and MAX marks on its side. Do not open the black or metal cap on the radiator or the tank while anything is warm, because the system is under pressure and the liquid is scalding.

5 minutes plus cooling time · None
2
Look for a leak on the ground and in the engine bay

With the car parked and cool, look at the ground near the front wheels and the middle of the engine bay for a wet patch. Coolant is usually bright green, orange, pink or blue and feels slippery, and it smells faintly sweet. Also look for dried crusty streaks on hoses and around the radiator, which show where it has been seeping.

5 minutes · None
3
Check the front of the car for blocked airflow

Look through the grille at the radiator from the front of the car. Leaves, a plastic bag, road debris or a thick layer of bugs across the face of it will stop air passing through and make the engine run hot, especially in slow traffic. Pull off anything loose by hand with the engine off and cold.

3 minutes · None
4
Read the temperature gauge and the manual page

If your dash has a temperature gauge, note where the needle sits when the warning appears and whether it climbs in traffic or at highway speed. Then look up the coolant warning in your owner's manual, which tells you exactly what your car means by that light. Both details save the shop guessing time later.

5 minutes · None

Step-by-step repair walkthroughs for the fixes below are on the way.

What not to do

  • Don't keep driving to 'see if it clears' with the red temperature light on, even for a few miles.
  • Don't open the radiator or coolant cap while the engine is warm; pressurised coolant can spray out and scald you.
  • Don't pour cold water into a hot engine, as the sudden shock can crack the head or block.
  • Don't restart and keep running the engine just to move the car further than the nearest safe spot.

What it usually turns out to be

Most likely first. Prices are typical US parts-and-labor totals for that repair, not a quote for your vehicle.

Low coolant from a leaking hose, clamp or tankPrice not verified

How you can tell The tank is below the MIN mark, and there is a wet or crusty trail on a hose end, a clamp or the plastic tank itself. The light often comes on in stages, hotter in traffic first. No stored code in many cases, or P0128 if the engine never reaches proper temperature.

The repair The shop pressure-tests the cooling system to find the leak, replaces the split hose, clamp or cracked tank, then refills and bleeds the air out of the system.

Thermostat stuck closedPrice not verified

How you can tell The engine heats up fast, within a few minutes of starting, and the upper radiator hose stays cool while the engine gets hot. Cabin heat may blow cold. Common codes are P0128 and P0217.

The repair The thermostat and its gasket or housing are replaced, and the coolant is refilled and bled.

Cooling fan not runningPrice not verified

How you can tell It runs fine on the highway but overheats sitting in traffic, in a drive-through or with the air conditioning on. The air conditioning may also cool poorly at a standstill. Codes in the P0480 to P0495 family often store.

The repair The shop tests the fan motor, relay and fuse, then replaces the fan motor or assembly, the relay or the wiring that feeds it.

Failed water pumpPrice not verified

How you can tell Often a whine or rumble from the front of the engine, coolant dripping from behind the belt area, and overheating that gets worse quickly. On belt-driven pumps the belt area may be damp or stained.

The repair The pump and its gasket are replaced. On engines where the timing belt drives the pump, the belt and tensioner are usually done at the same time.

Clogged or leaking radiatorPrice not verified

How you can tell Coolant drips from the front of the car, or the radiator overheats at steady speed even with a full tank and a working fan. Older cars with original coolant are the usual candidates.

The repair The radiator is replaced, the system flushed and refilled, and the hoses checked while it is apart.

Head gasket failurePrice not verified

How you can tell White sweet-smelling smoke from the tailpipe, bubbles in the coolant tank, coolant disappearing with no visible leak, or a rough running engine. The shop confirms it with a combustion-gas test on the coolant.

The repair The cylinder head comes off, the gasket is replaced and the head surface is checked and machined flat if needed. On a high-mileage car this is often the point where a replacement engine is compared.

What a shop will do

First they confirm the car is cool, check the coolant level and pressure-test the cooling system to look for leaks. Then they scan for stored codes, warm the engine up on a lift or with a scan tool watching the real coolant temperature, feel the hoses to see whether the thermostat opens, and check that the fan switches on. If nothing shows up they test the coolant for combustion gases to rule out a head gasket. Expect roughly an hour, longer if a slow leak has to be left to show itself.

How to reset this light

This is a fault warning, not a service reminder, so there is nothing to reset. It goes out on its own once the engine cools down or the coolant is topped up, and it will come straight back the next time the engine gets hot because the cause is still there. Clearing codes with a scan tool changes nothing about the problem.

If the light goes out after cooling, that is normal and is not a sign the fault is fixed.

Walk through it step by step

Trouble codes often stored with this light

Common questions

What does the engine temperature warning light mean?

The engine is overheating, or the coolant level is too low. If it's blue, the engine is just still cold.

Can I drive with the engine temperature warning light on?

Not if it's red. Pull over, turn the engine off and let it cool. Driving an overheating engine can warp the cylinder head or blow the head gasket.

How long can I drive with the engine temperature light on?

Treat it as zero miles. Pull over as soon as you can do it safely and shut the engine off. A few minutes of real overheating can warp the cylinder head or blow the head gasket, which turns a small repair into one of the most expensive jobs on the car.

Can I just add water instead of coolant?

Plain water will get you off the side of the road in an emergency, and clean tap water is better than running the engine dry. But it does not protect against freezing or rust, so have the shop drain it and refill with the correct coolant for your car soon after.

Will my car pass inspection with the temperature light on?

In states that check the dashboard, a lit red warning light is a fail, and in emissions states a related stored code will fail it too. More to the point, a shop should not be sending an overheating car back out on the road.

Does the light reset itself?

Yes, it usually goes out once the engine cools or the coolant level comes back up, and that fools a lot of drivers. The light going out only means the temperature came down, not that the leak, fan or thermostat was repaired.

Is it safe to restart the engine after it cools down?

Starting it to move a short distance to a safe spot is usually fine once it has fully cooled and the coolant is topped up. Watch the gauge the whole time and shut it off the moment it climbs again. If the tank empties straight back out, have it towed instead.

Sources: YourMechanic · CostHelper Cars · ThePricer · J.D. Power

Not your light? These get mixed up with it

Symbols vary a little between makes. Your owner's manual shows the exact lights for your vehicle. This is a general guide, not a diagnosis.