Home › Code lookup › P0118
Powertrain code · Cooling

P0118 Engine Coolant Temperature Sensor 1 Circuit High

How urgent? Get it checked in the next few days

What it means

The coolant temperature sensor is reporting an impossibly cold engine, usually because it's unplugged, a wire is broken, or the sensor has failed. The fans may not come on when needed.

Can I keep driving?

Watch for real overheating, since this code can make the gauge read wrong. If you see steam, smell coolant, the gauge reads high or the cooling fans aren't running, pull over and shut it off. Check the coolant level when the engine is cold. Otherwise get it to a shop soon.

What to test before replacing parts

Compare the coolant temperature reading to actual engine temperature with an infrared thermometer, check coolant level, and test the connector and wiring before replacing the sensor.

  1. Check that the sensor connector is fully plugged in and not corroded
  2. Read the live coolant temperature; a reading near minus 40 points to an open circuit
  3. Inspect the wiring along the engine for breaks

Signs you may notice

  • Check engine light on
  • Temperature gauge stays low or reads cold
  • Black smoke or rich running
  • Cooling fans may run all the time or not at all

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged or corroded sensor connector
  • CommonFailed coolant temperature sensor
  • PossibleBroken signal or ground wire
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Repair the connector or wiring, or replace the coolant temperature sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace coolant temperature sensor. Prepare an itemized shop request.
Walk through it step by step: Temperature gauge goes up and down →

Common questions

What does P0118 mean?

The coolant temperature sensor is reporting an impossibly cold engine, usually because it's unplugged, a wire is broken, or the sensor has failed. The fans may not come on when needed.

Can I drive with code P0118?

Watch for real overheating, since this code can make the gauge read wrong. If you see steam, smell coolant, the gauge reads high or the cooling fans aren't running, pull over and shut it off. Check the coolant level when the engine is cold. Otherwise get it to a shop soon.

What causes P0118?

Common possibilities to test include: unplugged or corroded sensor connector; failed coolant temperature sensor; broken signal or ground wire; engine computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.