Home › Code lookup › P0104
Powertrain code · Fuel and air

P0104 Mass or Volume Air Flow Sensor "A" Circuit Intermittent/Erratic

How urgent? Get it checked in the next few days

What it means

The air flow sensor's signal keeps cutting out or jumping around. That usually means a loose connection or a sensor that is starting to fail.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Wiggle the MAF connector and wiring with the engine running and watch for a stumble
  2. Inspect the connector pins for corrosion or spread terminals

Signs you may notice

  • Check engine light on
  • Occasional stumble, surge or stall
  • Problem may come and go with bumps or temperature

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLoose or corroded MAF connector
  • CommonIntermittent break in the wiring
  • PossibleFailing mass air flow sensor

Typical repair once the cause is confirmed

Repair the loose connection or wiring; replace the sensor if the signal still drops out.

Repair costInsufficient verified pricing for this vehicle and repair
Replace mass air flow sensor. Prepare an itemized shop request.
Walk through it step by step: Engine stalls while driving →

Common questions

What does P0104 mean?

The air flow sensor's signal keeps cutting out or jumping around. That usually means a loose connection or a sensor that is starting to fail.

Can I drive with code P0104?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0104?

Common possibilities to test include: loose or corroded maf connector; intermittent break in the wiring; failing mass air flow sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.