Home › Code lookup › P0107
Powertrain code · Fuel and air

P0107 Manifold Absolute Pressure/Barometric Pressure Circuit Low

How urgent? Get it checked in the next few days

What it means

The MAP sensor signal is lower than its normal range, which usually means a broken wire, a bad connection or a failed sensor.

Can I keep driving?

You can often drive gently to a shop, but it may run poorly. If the engine stalls, hesitates badly when pulling out or merging, or blows black smoke, keep trips short and avoid highways; a stall makes steering and braking much harder. Get it checked in the next few days.

What to test before replacing parts

Check the MAP connector, 5-volt reference, ground and signal wires before replacing the sensor; a lost reference can also affect other sensors on the same circuit.

  1. Check the MAP connector and look for damaged wiring
  2. Confirm the sensor has its 5-volt reference and a good ground
  3. Look for other codes that share the same 5-volt reference circuit

Signs you may notice

  • Check engine light on
  • Hard starting or stalling
  • Hesitation or lack of power
  • Rough idle

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged or corroded MAP sensor connector
  • CommonFailed MAP sensor
  • PossibleOpen or grounded signal wire, or lost 5-volt reference
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Repair the connector or wiring, or replace the MAP sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Walk through it step by step: Hard to start when cold →

Common questions

What does P0107 mean?

The MAP sensor signal is lower than its normal range, which usually means a broken wire, a bad connection or a failed sensor.

Can I drive with code P0107?

You can often drive gently to a shop, but it may run poorly. If the engine stalls, hesitates badly when pulling out or merging, or blows black smoke, keep trips short and avoid highways; a stall makes steering and braking much harder. Get it checked in the next few days.

What causes P0107?

Common possibilities to test include: unplugged or corroded map sensor connector; failed map sensor; open or grounded signal wire, or lost 5-volt reference; engine computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.