Home › Code lookup › P010C
Powertrain code · Fuel and air

P010C Mass or Volume Air Flow Sensor "B" Circuit Low

How urgent? Get it checked in the next few days

What it means

The signal from the second air flow sensor (sensor B) is lower than it should ever be, usually from a wiring problem or a failed sensor.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the sensor connector and wiring
  2. Measure the sensor's power, ground and signal

Signs you may notice

  • Check engine light on
  • Rough running or stalling
  • Weak acceleration

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged or corroded connector
  • CommonFailed air flow sensor B
  • PossibleOpen or grounded signal wire

Typical repair once the cause is confirmed

Repair the wiring or connector, or replace air flow sensor B.

Walk through it step by step: Check engine light on →

Common questions

What does P010C mean?

The signal from the second air flow sensor (sensor B) is lower than it should ever be, usually from a wiring problem or a failed sensor.

Can I drive with code P010C?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P010C?

Common possibilities to test include: unplugged or corroded connector; failed air flow sensor b; open or grounded signal wire. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.