Home › Code lookup › P0102
Powertrain code · Fuel and air

P0102 Mass or Volume Air Flow Sensor "A" Circuit Low

How urgent? Get it checked in the next few days

What it means

The air flow sensor's signal is lower than it should ever be, as if almost no air were entering the engine. This usually points to a wiring or connector problem, or a failed sensor.

Can I keep driving?

You can often drive gently to a shop, but it may run poorly. If the engine stalls, hesitates badly when pulling out or merging, or blows black smoke, keep trips short and avoid highways; a stall makes steering and braking much harder. Get it checked in the next few days.

What to test before replacing parts

Check that the MAF connector is seated and clean, test power, ground and signal wiring, and look for air leaks after the sensor before replacing the MAF.

  1. Check that the MAF connector is seated and the pins are clean
  2. Inspect the wiring harness near the air box
  3. Measure the sensor's power, ground and signal voltage

Signs you may notice

  • Check engine light on
  • Rough idle or stalling
  • Hard starting
  • Weak acceleration

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLoose, unplugged or corroded MAF connector
  • CommonFailed mass air flow sensor
  • PossibleOpen or shorted signal wire
  • PossibleLarge air leak after the sensor

Typical repair once the cause is confirmed

Repair the connector or wiring, or replace the mass air flow sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace mass air flow sensor. Prepare an itemized shop request.
Walk through it step by step: Rough idle or shaking when stopped →

Common questions

What does P0102 mean?

The air flow sensor's signal is lower than it should ever be, as if almost no air were entering the engine. This usually points to a wiring or connector problem, or a failed sensor.

Can I drive with code P0102?

You can often drive gently to a shop, but it may run poorly. If the engine stalls, hesitates badly when pulling out or merging, or blows black smoke, keep trips short and avoid highways; a stall makes steering and braking much harder. Get it checked in the next few days.

What causes P0102?

Common possibilities to test include: loose, unplugged or corroded maf connector; failed mass air flow sensor; open or shorted signal wire; large air leak after the sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.