Home › Code lookup › P0105
Powertrain code · Fuel and air

P0105 Manifold Absolute Pressure/Barometric Pressure Circuit

How urgent? Get it checked in the next few days

What it means

There's an electrical problem with the MAP sensor, which measures the pressure (vacuum) inside the intake manifold. The computer uses it to judge engine load and fuel needs.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the MAP sensor connector and wiring
  2. Measure the sensor's reference voltage, ground and signal

Signs you may notice

  • Check engine light on
  • Rough idle or hesitation
  • Poor fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonDamaged or unplugged MAP sensor connector
  • CommonFailed MAP sensor
  • PossibleOpen or shorted wiring to the sensor

Typical repair once the cause is confirmed

Repair the wiring or connector, or replace the MAP sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Walk through it step by step: Check engine light on →

Common questions

What does P0105 mean?

There's an electrical problem with the MAP sensor, which measures the pressure (vacuum) inside the intake manifold. The computer uses it to judge engine load and fuel needs.

Can I drive with code P0105?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0105?

Common possibilities to test include: damaged or unplugged map sensor connector; failed map sensor; open or shorted wiring to the sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.