Home › Code lookup › P0108
Powertrain code · Fuel and air

P0108 Manifold Absolute Pressure/Barometric Pressure Circuit High

How urgent? Get it checked in the next few days

What it means

The MAP sensor signal is higher than its normal range. This often comes from a vacuum hose that has come off, a wiring short, or a failed sensor.

Can I keep driving?

You can often drive gently to a shop, but it may run poorly. If the engine stalls, hesitates badly when pulling out or merging, or blows black smoke, keep trips short and avoid highways; a stall makes steering and braking much harder. Get it checked in the next few days.

What to test before replacing parts

Check the MAP vacuum hose, sensor ground and signal wire, and measure actual engine vacuum with a gauge before replacing the sensor.

  1. Check the vacuum supply to the MAP sensor
  2. Inspect the sensor wiring and ground
  3. Check engine vacuum with a gauge

Signs you may notice

  • Check engine light on
  • Rough running or black smoke
  • Poor fuel economy
  • Hesitation

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonDisconnected or split vacuum hose to the MAP sensor
  • CommonFailed MAP sensor
  • PossibleSignal wire shorted to voltage or open ground
  • PossibleVery low engine vacuum from a mechanical problem

Typical repair once the cause is confirmed

Reconnect or replace the vacuum hose, repair wiring, or replace the MAP sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Walk through it step by step: Black smoke from exhaust →

Common questions

What does P0108 mean?

The MAP sensor signal is higher than its normal range. This often comes from a vacuum hose that has come off, a wiring short, or a failed sensor.

Can I drive with code P0108?

You can often drive gently to a shop, but it may run poorly. If the engine stalls, hesitates badly when pulling out or merging, or blows black smoke, keep trips short and avoid highways; a stall makes steering and braking much harder. Get it checked in the next few days.

What causes P0108?

Common possibilities to test include: disconnected or split vacuum hose to the map sensor; failed map sensor; signal wire shorted to voltage or open ground; very low engine vacuum from a mechanical problem. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.