Home › Code lookup › P0106
Powertrain code · Fuel and air

P0106 Manifold Absolute Pressure/Barometric Pressure Circuit Range/Performance

How urgent? Book a check when convenient

What it means

The MAP sensor's reading doesn't make sense for how the engine is running. Often a cracked vacuum hose, a leak, or a lazy sensor is to blame.

Can I keep driving?

Usually drivable for now, but hesitation can be risky when merging or crossing traffic. Get it checked within a week or two. If it stalls, stumbles badly, runs very rough, or the check engine light starts flashing, get it looked at right away.

What to test before replacing parts

Inspect the MAP vacuum hose, compare the MAP reading to barometric pressure with the key on and engine off, and check engine vacuum with a gauge before replacing the sensor.

  1. Inspect the MAP sensor hose, seal or grommet for cracks
  2. Compare the MAP reading with key on, engine off to the local barometric pressure
  3. Check engine vacuum with a gauge

Signs you may notice

  • Check engine light on
  • Rough idle
  • Hesitation or weak acceleration
  • Worse fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonCracked or disconnected vacuum hose to the MAP sensor
  • CommonFaulty MAP sensor
  • PossibleIntake vacuum leak
  • PossibleEngine mechanical problem causing low vacuum
  • PossibleCorroded connector or poor ground

Typical repair once the cause is confirmed

Fix the vacuum hose or leak; replace the MAP sensor if its readings are still off.

Repair costInsufficient verified pricing for this vehicle and repair

Where it shows up

  • A cracked vacuum hose or worn sensor seal is a frequent trigger on older trucks

Known on these vehicles

Walk through it step by step: Rough idle or shaking when stopped →

Common questions

What does P0106 mean?

The MAP sensor's reading doesn't make sense for how the engine is running. Often a cracked vacuum hose, a leak, or a lazy sensor is to blame.

Can I drive with code P0106?

Usually drivable for now, but hesitation can be risky when merging or crossing traffic. Get it checked within a week or two. If it stalls, stumbles badly, runs very rough, or the check engine light starts flashing, get it looked at right away.

What causes P0106?

Common possibilities to test include: cracked or disconnected vacuum hose to the map sensor; faulty map sensor; intake vacuum leak; engine mechanical problem causing low vacuum. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.