Home › Code lookup › P0103
Powertrain code · Fuel and air

P0103 Mass or Volume Air Flow Sensor "A" Circuit High

How urgent? Get it checked in the next few days

What it means

The air flow sensor's signal is higher than it should ever be, as if a huge amount of air were rushing in. This is usually an electrical fault in the sensor or its wiring.

Can I keep driving?

You can often drive gently to a shop, but it may run poorly. If the engine stalls, hesitates badly when pulling out or merging, or blows black smoke, keep trips short and avoid highways; a stall makes steering and braking much harder. Get it checked in the next few days.

What to test before replacing parts

Check MAF power, ground and signal voltage with the engine running, and look for wiring routed near ignition parts or the alternator before replacing the sensor.

  1. Inspect the MAF wiring for rubbed-through or melted spots
  2. Check the sensor ground connection
  3. Compare the signal voltage with the engine off and at idle

Signs you may notice

  • Check engine light on
  • Rough running or black smoke
  • Stalling or hesitation
  • Poor fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed mass air flow sensor
  • CommonSignal wire shorted to a voltage source
  • PossiblePoor ground at the sensor
  • PossibleWiring routed too close to ignition parts or the alternator

Typical repair once the cause is confirmed

Repair the shorted wiring or replace the mass air flow sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace mass air flow sensor. Prepare an itemized shop request.
Walk through it step by step: Black smoke from exhaust →

Common questions

What does P0103 mean?

The air flow sensor's signal is higher than it should ever be, as if a huge amount of air were rushing in. This is usually an electrical fault in the sensor or its wiring.

Can I drive with code P0103?

You can often drive gently to a shop, but it may run poorly. If the engine stalls, hesitates badly when pulling out or merging, or blows black smoke, keep trips short and avoid highways; a stall makes steering and braking much harder. Get it checked in the next few days.

What causes P0103?

Common possibilities to test include: failed mass air flow sensor; signal wire shorted to a voltage source; poor ground at the sensor; wiring routed too close to ignition parts or the alternator. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.