Home › Warning lights › Power steering warning light
Amber/yellow: check soon

Power steering warning light

Also called: EPS light, Steering wheel with !

How urgent? Get it checked soon

What it means

The power steering assist has a fault and may be reduced or off. Steering will feel heavy, especially at low speed.

It appears in the instrument cluster, usually amber. The common symbol is a steering wheel seen from the front with an exclamation mark beside it. Some cars show letters instead, EPS on Honda and Hyundai, EPAS or PS on others, and many newer cars simply print a message like Power Steering Fault or Service Power Steering in the driver display. A red version means assist has already dropped out.

Can I keep driving?

You can usually steer, but it takes much more effort. Drive carefully to a shop; avoid it if steering is very heavy.

What to do now

  1. Restart the car once; some electric systems reset.
  2. Check for a low battery or charging problem (it can trigger this).
  3. On hydraulic systems, check the power steering fluid.

Common causes

  • Electric power steering motor or sensor fault
  • Low battery voltage
  • Low power steering fluid (hydraulic)
  • Steering column or wiring problem

Checks you can do yourself

Safe, no tools in most cases

Do these with the car parked and the engine off and cool. If anything looks or smells hot, wait.

1
Shut the engine off and start it again

Pull over somewhere safe, switch the engine fully off, wait about half a minute, then restart. Electric systems often shut the assist down for the rest of a trip after a dip in voltage and then come back fine. If the light stays on after two restarts, it is a real fault and not a glitch.

5 minutes · None
2
Check the power steering fluid, if your car has any

Many newer cars are fully electric and have no steering fluid at all. If yours has a power steering reservoir, find it with the engine cold and off, wipe the cap, and read the level against the marks on the side of the tank. A low level, or fluid that looks dark and foamy instead of clear red or amber, points at a leak and needs a shop.

10 minutes · Clean rag
3
Look at the battery terminals

A weak battery or a loose, crusty terminal is one of the most common reasons an electric steering system shuts itself down. With the engine off, look at the two posts on top of the battery for white or green powder, and check by hand that neither cable can be wiggled. Most parts stores will test the battery for free while you wait.

10 minutes · None
4
Check the steering fuse in the cabin box

Your owner's manual shows which fuse feeds the steering system and where the box is, often in the driver's footwell or behind the glovebox. With the car switched off, pull that fuse with the little puller in the box lid and hold it up to the light. A broken metal strip inside means it has blown. Fit a new one of exactly the same number, and if it blows again stop and let a shop find out why.

15 minutes · Fuse puller
5
Feel how heavy the steering really is

In an empty parking spot, with the engine running, the car in park and the parking brake on, turn the wheel slowly from side to side. If it moves with close to normal effort, assist is still working and you can drive carefully to a shop. If it takes both arms and real force, the car is dangerous to park and should be towed instead.

3 minutes · None

Step-by-step repair walkthroughs for the fixes below are on the way.

What not to do

  • Don't drive it if the wheel is so heavy you could not turn into a parking space at walking pace. Have it towed.
  • Don't keep topping up the fluid without finding the leak. Running the pump dry ruins it.
  • Don't put anything in the reservoir except the exact fluid the cap or the manual names.
  • Don't take it on the highway assuming the assist will stay on. Electric systems can drop out with no warning.

What it usually turns out to be

Most likely first. Prices are typical US parts-and-labor totals for that repair, not a quote for your vehicle.

Weak battery or charging faultPrice not verified

How you can tell The steering goes heavy for a second then comes back, and there is often a slow crank, dim lights, or the battery light on too. Electric power steering draws a lot of current, so it is the first thing the car switches off when voltage sags. A battery test usually finds it in minutes.

The repair A new battery, or repair of the alternator or a corroded main cable. The steering light clears once voltage is steady again.

Steering torque or angle sensor failurePrice not verified

How you can tell Assist cuts out suddenly, often only in one direction or at one point in the turn, so the wheel feels heavy going left and normal going right. The stored code names the torque sensor or the steering angle sensor.

The repair On most cars the sensor is built into the steering column or the rack, so that whole assembly is replaced and then calibrated with a scan tool.

Low fluid or a leak, on cars with hydraulic steeringPrice not verified

How you can tell Only on cars with a belt-driven pump and a reservoir. You hear a whine or groan as you turn, the steering is heaviest at parking speed, and there are reddish or light brown drips where you park.

The repair The leaking hose, seal or rack is replaced, then the system is refilled and the air bled out.

Power steering pump wearing out, on hydraulic carsPrice not verified

How you can tell A loud whine that rises in pitch as you turn the wheel, with steering heavy in a parking lot but close to normal on the highway. The fluid may look dark with fine metal glitter in it.

The repair A new or rebuilt pump, a look at the drive belt, fresh fluid and the air bled out.

Wiring, connector or fuse at the steering columnPrice not verified

How you can tell The light comes and goes, often over a bump or on a cold morning, and the assist returns by itself. A shop traces it to a chafed wire, a corroded connector pin or a fuse that has blown once.

The repair The damaged wire or connector is repaired and a new fuse of the correct rating is fitted.

Electric steering motor or control module failurePrice not verified

How you can tell The steering is heavy from the moment you start the car, every trip, and the light is on every time. The scan tool either stores an internal motor or module fault, or cannot talk to the steering module at all.

The repair The motor and module unit on the column or rack is replaced or rebuilt, then programmed and calibrated to the car.

What a shop will do

They read the steering module with a scan tool, which usually means a shop or dealer because a basic code reader cannot see these codes. They test the battery and charging system first, since low voltage imitates a steering fault and gets replaced parts thrown at it for nothing. Then the fuse, the connectors at the column, and the live readings from the torque sensor while the wheel is turned. Under an hour when a clear code is stored, longer for a fault that only shows up now and then.

How to reset this light

No. This is a fault light, not a service reminder. Clearing the code turns the light out for a moment, but the car tests the steering system every time you start it, so the light comes back on that drive or the next one and the assist stays weak. The one thing that looks like a reset is the single-trip shutdown some electric systems do after a voltage dip. Shut the engine off, start it again, and if that was all it was the light stays out.

After a real repair, a steering column, rack or sensor normally has to be calibrated with a scan tool before the light will stay off.

Walk through it step by step

Trouble codes often stored with this light

Common questions

What does the power steering warning light mean?

The power steering assist has a fault and may be reduced or off. Steering will feel heavy, especially at low speed.

Can I drive with the power steering warning light on?

You can usually steer, but it takes much more effort. Drive carefully to a shop; avoid it if steering is very heavy.

Can I still steer if the power steering light is on?

Yes. The steering wheel is still connected to the wheels mechanically, you have only lost the help. At highway speed you may barely notice. At parking speed it can take both arms and real effort, and that is where people get caught out.

Will the power steering light fail an inspection?

A lit steering warning lamp can fail a state safety inspection, and a car that is genuinely hard to steer will fail on that alone. The rules differ by state. It is not part of the emissions test.

How long can I drive with the power steering light on?

Think days, not weeks, and only while the steering still feels close to normal. If the assist has already dropped out and the wheel is heavy, drive straight to a shop or have it towed. The real risk is a tight turn or a sudden swerve you cannot make quickly enough.

Does the power steering light reset itself?

Sometimes. If the cause was a brief voltage dip or a one-off glitch, it goes out after you restart the engine and does not return. If it is back every trip, the car has stored a real fault and the light stays on until the repair is done.

Is it safe to drive at night or on the highway with this light on?

The highway needs the least assist, so the car feels nearly normal there. The danger is at the ends of the trip, parking, a tight turn, or an emergency swerve. Keep both hands on the wheel, slow down earlier than usual, and skip long trips until it is fixed.

Sources: YourMechanic

Symbols vary a little between makes. Your owner's manual shows the exact lights for your vehicle. This is a general guide, not a diagnosis.