Home › Warning lights › Security / immobilizer light
Amber/yellow: check soon

Security / immobilizer light

Also called: Key light, Anti-theft light, Car with lock

How urgent? Check it when you can

What it means

Blinking with the car off is normal: it shows the anti-theft system is armed. If it stays on or flashes and the car won't start, the car doesn't recognize the key.

A small amber or red symbol in the instrument cluster, often low down near the fuel gauge or off to one side. Most makes draw a car outline with a padlock over it; Toyota, Nissan and Hyundai often show a car with a key inside it instead. Older GM trucks and cars simply spell out the word SECURITY, and a few Hondas use a plain green key outline.

Can I keep driving?

If it starts and runs normally, you can drive it locally - but treat every shutdown as a gamble on the next start, so stay near home and keep a tow number handy. If it cranks and will not fire, or fires and dies after a second, try the spare key and then stop using the car.

If it's flashing or blinking: A slow, steady blink once every second or two while the car is locked and switched off is normal - that is the anti-theft system standing guard. A fast blink, or a light that stays solid once you turn the key on, is the car telling you it cannot read the key, and that is when it usually will not start.

What to do now

  1. Try the spare key.
  2. Replace the key fob battery.
  3. Lock and unlock the doors with the key, then try again.

Common causes

  • Weak key fob battery
  • Damaged key chip
  • Immobilizer or antenna ring fault

Checks you can do yourself

Safe, no tools in most cases

Do these with the car parked and the engine off and cool. If anything looks or smells hot, wait.

1
Try your spare key

Get the other key or fob and try starting the car with it. If the spare works, the problem is in the key you were using - a worn chip or a dead battery inside it. If neither key works, the fault is in the car and not the keys, which is useful to know before anyone sells you a new key.

2 minutes · Spare key
2
Replace the battery in the key fob

Most fobs pop open along a seam with a coin or a small flat screwdriver and take one flat coin battery. Note which side faces up before you take the old one out, put the new one in the same way, and snap the fob back together. A weak fob battery is the single most common reason a car stops recognising its key.

5 minutes · Coin or small flat screwdriver
3
Hold the key against the start button or column

Take the key off the ring and move your phone, wallet and any other fobs away from it. Press the key or fob flat against the start button, or against the plastic around the ignition on a car with a turn key, then try to start. Cars keep a backup reader there for exactly this situation.

2 minutes · None
4
Let the car relearn the key

Sit in the car, turn the key to the on position without cranking, and leave it there for ten to fifteen minutes while the security light does its thing. When the light stops blinking, switch off, wait a minute, then try to start. Many cars accept the key again after this wait. It costs nothing to try, and it does not work on every make.

20 minutes · None
5
Look at the battery terminals

With the engine off and cold, open the hood and look at the two posts on top of the battery. You want clean metal and clamps that do not move when you nudge them by hand. White or blue fluff, or a clamp you can wiggle, means poor voltage, and a security system that is short on volts will refuse the key. Have a shop clean and tighten them.

5 minutes · None

Step-by-step repair walkthroughs for the fixes below are on the way.

What not to do

  • Don't crank it over and over - you'll flatten the battery, and many systems lock you out for several minutes after a few failed attempts.
  • Don't buy a new key before the car has been scanned; the fault is in the car just as often as in the key.
  • Don't rely on the car for a long trip if it starts only after a few tries - the next time it may not restart at all.
  • Don't try to bypass or hot-wire the system; on most modern cars that just adds an expensive module fault.

What it usually turns out to be

Most likely first. Prices are typical US parts-and-labor totals for that repair, not a quote for your vehicle.

Weak or dead key fob batteryPrice not verified

How you can tell The remote lock and unlock buttons stop working from a distance, or only work right next to the car. The car may still start if you hold the key against the start button. No fault codes stored, or a stored code about the key not being read.

The repair A new coin battery in the fob. A parts store or hardware store has them, and the shop will put one in while you wait.

Worn or damaged transponder keyPrice not verified

How you can tell One key works and the other does not, or the key only works if you hold it at a certain angle. Often follows the key being dropped, washed or carried loose in a pocket for years. A scan shows the car is not receiving a key signal.

The repair A new key is cut and then programmed to your car so it is the only one that will start it. A locksmith who does car keys is usually cheaper than the dealer.

Weak 12-volt battery or corroded terminalsPrice not verified

How you can tell Slow cranking, dim dash lights, several warning lights on at once, or the trouble starts after the car sat for a few days. Often shows up on a cold morning and clears once the car is jump started.

The repair The battery is tested, and either the terminals are cleaned and tightened or the battery is replaced.

Faulty antenna ring or key readerPrice not verified

How you can tell Both keys fail, and the car cranks but will not fire, or fires and dies after a second or two. A scan tool shows no key signal at all even with a known good key. Common on cars with a turn key and high mileage on the ignition.

The repair The ring or reader around the ignition or start button is replaced and the keys are matched to it again.

Ignition lock cylinder or anti-theft sensor faultPrice not verified

How you can tell The key feels loose or sticky in the ignition, or the light comes on only when you hit a bump or turn the wheel. Very common on older GM cars and trucks that use a sensor in the lock rather than a chip in the key.

The repair The lock cylinder and its sensor are replaced and the car is taught the new part, which takes a wait of up to half an hour on some cars.

Immobilizer or body control module failurePrice not verified

How you can tell Both keys fail, the battery and wiring check out, and a scan shows the module itself not answering or reporting an internal fault. Sometimes starts after the car has been in water, or after someone else replaced a computer on it.

The repair The module is replaced and then programmed to your car and your keys, which needs dealer-level equipment on most makes.

What a shop will do

A shop starts with a scan tool that reads the body and security modules, not a cheap plug-in code reader, because the fault lives there rather than in the engine computer. They check battery voltage, then watch live data to see whether the car is picking up the key at all, and wiggle the wiring at the base of the steering column while they watch. From there it is a test of the reader, the module and each key. Expect about an hour, longer if the fault comes and goes.

How to reset this light

This is a fault light, not a reminder, so there is nothing you are meant to reset. Clearing the code with a scan tool wipes the light for a moment, but the car still does not trust the key, so it comes straight back - usually the next time you shut the engine off. There is a real key relearn procedure, but it belongs at the end of a repair, after the bad key, reader or module has been replaced.

The relearn is different on every make, and on many cars it needs equipment only a dealer or a car locksmith has.

Walk through it step by step

Trouble codes often stored with this light

Common questions

What does the security / immobilizer light mean?

Blinking with the car off is normal: it shows the anti-theft system is armed. If it stays on or flashes and the car won't start, the car doesn't recognize the key.

Can I drive with the security / immobilizer light on?

If it starts and runs normally, you can drive it locally - but treat every shutdown as a gamble on the next start, so stay near home and keep a tow number handy. If it cranks and will not fire, or fires and dies after a second, try the spare key and then stop using the car.

Will my car pass inspection with the security light on?

On its own the security light is not part of an emissions test, so in most states it does not fail you. The trouble is that a car which will not start cannot be tested at all, and some of these faults also switch on the check engine light, which does fail the test in states that read the computer.

Can I keep driving with the security light on?

If the engine starts and runs normally, yes, for short local trips. Treat it as a warning that the next start is not guaranteed, so do not head out of town or park somewhere you cannot be towed from. If the car starts and then shuts off on its own, stop using it and get it looked at.

Does the security light reset itself?

Sometimes. If it came on because the fob battery was fading or the car was low on voltage, it often clears on its own once that is fixed. If it keeps coming back, something in the system is failing and it will not sort itself out.

Why does my car start and then die a second later?

That is the anti-theft system doing its job. The engine is allowed to fire, then the computer cuts the fuel because it never got the right code back from the key. It points at the key, the reader around the ignition, or the module - not at the engine itself.

Is a locksmith cheaper than the dealer for a new key?

Usually, and a mobile car locksmith can often cut and program a key at your house, which saves a tow. Check that they handle your make, because some newer cars and most push-button keys still need dealer equipment.

Sources: Rick's Free Auto Repair Advice · YourMechanic · Car Treatments

Not your light? These get mixed up with it

Symbols vary a little between makes. Your owner's manual shows the exact lights for your vehicle. This is a general guide, not a diagnosis.