Home › Code lookup › P0513
Powertrain code · Electrical

P0513 Incorrect Immobilizer Key

How urgent? Get it checked in the next few days

What it means

The anti-theft system doesn't recognize the key, so the computer may block the engine from starting.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Try the spare key
  2. Replace the key fob battery on push-button start cars
  3. Have a shop or dealer check key programming

Signs you may notice

  • Engine will not start, or starts and dies right away
  • Security light on or flashing

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonKey not programmed to the vehicle
  • CommonDamaged chip in the key
  • PossibleFaulty antenna ring around the ignition
  • PossibleWeak key fob battery (push-button start)
  • PossibleFaulty immobilizer module

Typical repair once the cause is confirmed

Usually programming or replacing the key; sometimes an antenna or immobilizer module.

Walk through it step by step: Security light flashing, won't start →

Common questions

What does P0513 mean?

The anti-theft system doesn't recognize the key, so the computer may block the engine from starting.

Can I drive with code P0513?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0513?

Common possibilities to test include: key not programmed to the vehicle; damaged chip in the key; faulty antenna ring around the ignition; weak key fob battery (push-button start). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.