Water in fuel light (diesel)
Also called: Water in fuel filter light, WIF light, Drain fuel filter light, Water separator light
What it means
Water has collected in the diesel fuel filter or water separator. Water in diesel does not burn, and it rusts and scores the injectors and the high-pressure pump.
It sits in the main instrument cluster, is always amber, and only appears on diesels. Most makes draw a fuel filter canister with a drain tap at the bottom and water droplets in it. Many American diesel trucks skip the picture and simply spell out WATER IN FUEL or DRAIN FUEL FILTER in the message screen between the gauges.
Can I keep driving?
Short, gentle trips are usually fine, but treat it as a same-day job. Drain the separator or get the filter changed before any long drive, and stop driving if the engine starts running rough, losing power or blowing white smoke.
What to do now
- Drain the water separator if your truck has a drain valve. Most diesel pickups do, and the owner's manual shows where it is.
- Look up 'water in fuel' in the owner's manual. It says whether yours drains by hand, by a dash button, or only at a shop.
- Think about where you last filled up. One bad tank of diesel is the usual cause of a sudden warning.
- If the light stays on after a proper drain, have the fuel filter replaced and the water-in-fuel sensor tested.
Common causes
- Water collected in the filter or separator from normal use
- Contaminated diesel from a filling station
- Fuel filter long past its service life
- Moisture condensing in a tank that sits part empty
- Faulty water-in-fuel sensor
- Cracked fuel cap seal or leaking filter housing letting water in
Checks you can do yourself
Safe, no tools in most casesDo these with the car parked and the engine off and cool. If anything looks or smells hot, wait.
With the engine off and cold, open the hood and find the fuel filter canister. Most diesel pickups have a drain valve on the bottom of it. Put a jar underneath, open the valve by hand a turn or two, let the water and a little fuel run out until clean diesel comes, then close it finger tight. The owner's manual shows the exact spot. What comes out is mostly fuel, so keep it away from flames and take it to a recycling center.
5-10 minutes · A jar or catch bottleLook up 'water in fuel' or 'fuel filter' in the index. It tells you whether your truck has a hand drain, where it is, and how often the filter is meant to be changed. Some models want the water-in-fuel sensor swapped every time the filter is changed, which is worth knowing before you book the job.
10 minutes · NoneEngine off and cool, shine a flashlight on the filter canister. Look for diesel weeping around the cap seal or the drain valve, and for a wet, dirty patch below it. A housing that leaks fuel out also lets air and water in, which is why the light keeps coming back after every drain.
5 minutes · A flashlightOpen the fuel door and look at the rubber ring on the cap. If it is cracked, hard or missing, rain and car wash water can run down into the filler neck. Wipe the neck clean, put the cap back until it clicks, and replace a damaged cap. This is the one cause a driver can fix outright.
3 minutes · NoneStep-by-step repair walkthroughs for the fixes below are on the way.
What not to do
- Don't set off on a long highway trip with it on. Water in diesel ruins injectors and the high-pressure pump, and those are the costly parts.
- Don't keep refuelling at the same pump if the light appeared within a day of filling up there.
- Don't pour in an alcohol-based water remover on a modern common-rail diesel unless the owner's manual names that product.
- Don't drain the separator near a flame or while smoking. What comes out of it is mostly fuel.
What it usually turns out to be
Most likely first. Prices are typical US parts-and-labor totals for that repair, not a quote for your vehicle.
How you can tell By far the commonest one, especially on a truck that sits a lot or only does short trips. A little cloudy water drains out, the light goes off, and it creeps back over the following weeks or months.
The repair A shop drains the separator and normally fits a fresh fuel filter at the same time, since the old one has been sitting in water.
How you can tell The light comes on within a day or two of filling up, often alongside hard starting, rough running or white smoke. What drains out looks milky and there is a lot of it rather than a dribble.
The repair Drain the separator and replace the filter. In bad cases the tank has to come down to be cleaned and the fuel lines flushed through.
How you can tell High mileage since the last filter change, maybe a slight flat spot when you accelerate hard, and the light returning within days of each drain because the filter can no longer hold anything back.
The repair Replace the diesel fuel filter. Some trucks have two, one on the engine and one under the body, and both get done.
How you can tell The light is on but only clean fuel drains out and the engine runs perfectly. The stored code names the water-in-fuel circuit, and a shop can see the sensor reading water that is not there.
The repair Replace the sensor in the fuel filter housing. On many models it comes as part of the filter kit.
How you can tell The light comes and goes, often over bumps or in wet weather. A shop finds a chafed wire, a bent pin, or a connector packed with green corrosion at the sensor plug.
The repair Repair or replace the connector and the short length of damaged wiring behind it.
What a shop will do
The first thing a shop does is open the drain on the water separator and look at what comes out: clean diesel, or cloudy water. Then it reads the stored codes, checks the water-in-fuel sensor and its wiring, and looks the filter housing over for leaks. If a lot of water drains out they will take a fuel sample and check the tank too. Draining and a filter change is usually under an hour. Chasing a sensor or wiring fault is about an hour of diagnosis.
How to reset this light
This is not a reminder, so there is nothing to reset. On most diesels the light goes out by itself a short time after the water is drained and the engine has run, sometimes after switching the key off and on. If it stays on, either water is still sitting in the filter or the sensor or its wiring has a fault. Clearing the code with a scan tool will not fix either one, and the light will be back.
A few makes need the fuel system primed or bled after a drain, and the owner's manual says whether yours is one of them.
Common questions
What does the water in fuel light (diesel) mean?
Water has collected in the diesel fuel filter or water separator. Water in diesel does not burn, and it rusts and scores the injectors and the high-pressure pump.
Can I drive with the water in fuel light (diesel) on?
Short, gentle trips are usually fine, but treat it as a same-day job. Drain the separator or get the filter changed before any long drive, and stop driving if the engine starts running rough, losing power or blowing white smoke.
How long can I drive with the water in fuel light on?
Treat it as a same-day job rather than an emergency. Short, gentle trips are usually fine. But water in diesel scores the injectors and the high-pressure pump, which are the most expensive parts of the fuel system, so get it drained before any long drive and stop if the engine runs rough or smokes.
Does the light clear itself after I drain the water out?
Usually yes. Once the water is gone and the engine has run for a few minutes the light goes off on its own, sometimes after a key off and on. If it is still on after a proper drain, either water is still in the filter or the sensor itself has failed.
Can I just add a water remover additive instead?
On older diesels some additives help with small amounts of water. On a modern common-rail diesel, add nothing unless the owner's manual names the product, because the wrong one can damage injectors. Draining and a fresh filter is the only fix that actually takes the water out.
Where did the water come from?
Most often from the filling station's own tank, or from moisture condensing inside your tank when it sits part empty through warm days and cold nights. Rain or wash water getting past a cracked fuel cap seal is a less common third way.
Will it fail an inspection or emissions test?
The warning on its own is not usually an inspection item in the United States. But if the trouble has also set an emissions code and lit the check engine light, that can fail you. Rules differ by state, so check your own state's list.
Sources: YourMechanic · RepairPal