P020D Cylinder 4 Injection Timing
What it means
The computer has detected that fuel is being injected into cylinder 4 at the wrong moment. This code mostly shows up on modern diesel and direct-injection engines.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Fix any fuel pressure or injector circuit codes first
- Inspect the cylinder 4 injector connector and wiring
- If injectors were replaced recently, confirm their trim codes were programmed
Signs you may notice
- Check engine light on
- Rough running, knocking or a misfire
- Smoke from the exhaust or worse fuel economy
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty or sticking injector on cylinder 4
- CommonInjector wiring or connector problem
- PossibleInjector correction (trim) codes not programmed after injector replacement
- PossibleLow or unstable fuel rail pressure
- PossibleEngine computer software issue
Typical repair once the cause is confirmed
Most often a new injector for that cylinder, programmed to the engine computer, after wiring and fuel pressure problems are ruled out.
Common questions
What does P020D mean?
The computer has detected that fuel is being injected into cylinder 4 at the wrong moment. This code mostly shows up on modern diesel and direct-injection engines.
Can I drive with code P020D?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P020D?
Common possibilities to test include: faulty or sticking injector on cylinder 4; injector wiring or connector problem; injector correction (trim) codes not programmed after injector replacement; low or unstable fuel rail pressure. A shop should confirm the cause before replacing parts.