Home › Code lookup › P0210
Powertrain code · Fuel and air

P0210 Injector Circuit/Open - Cylinder 10

How urgent? Get it checked in the next few days

What it means

The engine computer sees a problem in the wiring or electrical signal for the fuel injector on cylinder 10, so that cylinder may not be getting fuel.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look for a loose, broken or corroded connector at the cylinder 10 injector
  2. Measure the injector's resistance and compare it with the other injectors
  3. Use a noid light or scope to confirm the computer is pulsing the injector

Signs you may notice

  • Check engine light on
  • Rough idle or shaking
  • Misfire or stumble, often with a cylinder 10 misfire code
  • Less power and worse fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty fuel injector on cylinder 10 (open or shorted coil)
  • CommonLoose, damaged or corroded injector connector
  • PossibleBroken or chafed injector wire in the harness
  • PossibleBlown fuse or lost power feed to the injectors
  • PossibleFaulty injector driver inside the engine computer

Typical repair once the cause is confirmed

Usually a new cylinder 10 injector or a wiring or connector repair. The engine computer itself is rarely the cause.

Repair costInsufficient verified pricing for this vehicle and repair
Replace fuel injector (cylinder 10). Prepare an itemized shop request.
Walk through it step by step: Engine sputters or misfires →

Common questions

What does P0210 mean?

The engine computer sees a problem in the wiring or electrical signal for the fuel injector on cylinder 10, so that cylinder may not be getting fuel.

Can I drive with code P0210?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0210?

Common possibilities to test include: faulty fuel injector on cylinder 10 (open or shorted coil); loose, damaged or corroded injector connector; broken or chafed injector wire in the harness; blown fuse or lost power feed to the injectors. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.