P0211 Injector Circuit/Open - Cylinder 11
What it means
The engine computer sees a problem in the wiring or electrical signal for the fuel injector on cylinder 11, so that cylinder may not be getting fuel.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look for a loose, broken or corroded connector at the cylinder 11 injector
- Measure the injector's resistance and compare it with the other injectors
- Use a noid light or scope to confirm the computer is pulsing the injector
Signs you may notice
- Check engine light on
- Rough idle or shaking
- Misfire or stumble, often with a cylinder 11 misfire code
- Less power and worse fuel economy
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty fuel injector on cylinder 11 (open or shorted coil)
- CommonLoose, damaged or corroded injector connector
- PossibleBroken or chafed injector wire in the harness
- PossibleBlown fuse or lost power feed to the injectors
- PossibleFaulty injector driver inside the engine computer
Typical repair once the cause is confirmed
Usually a new cylinder 11 injector or a wiring or connector repair. The engine computer itself is rarely the cause.
Common questions
What does P0211 mean?
The engine computer sees a problem in the wiring or electrical signal for the fuel injector on cylinder 11, so that cylinder may not be getting fuel.
Can I drive with code P0211?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0211?
Common possibilities to test include: faulty fuel injector on cylinder 11 (open or shorted coil); loose, damaged or corroded injector connector; broken or chafed injector wire in the harness; blown fuse or lost power feed to the injectors. A shop should confirm the cause before replacing parts.