Home › Code lookup › P0213
Powertrain code · Fuel and air

P0213 Cold Start Injector 1

How urgent? Book a check when convenient

What it means

Some older engines used an extra injector to add fuel during cold starts. The computer sees a problem with cold start injector 1 or its wiring.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the cold start injector connector and wiring
  2. Measure the injector's resistance against the spec
  3. Test the thermo-time switch if the engine has one

Signs you may notice

  • Check engine light on
  • Hard starting when the engine is cold
  • Fuel smell or rough running if the injector leaks

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty cold start injector
  • CommonDamaged wiring or corroded connector
  • PossibleFaulty thermo-time switch that controls the injector
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a wiring repair or a new cold start injector.

Walk through it step by step: Hard to start when cold →

Common questions

What does P0213 mean?

Some older engines used an extra injector to add fuel during cold starts. The computer sees a problem with cold start injector 1 or its wiring.

Can I drive with code P0213?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0213?

Common possibilities to test include: faulty cold start injector; damaged wiring or corroded connector; faulty thermo-time switch that controls the injector; engine computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.