Home › Code lookup › P0215
Powertrain code · Fuel and air

P0215 Engine Shutoff Solenoid

How urgent? Get it checked in the next few days

What it means

Many diesel engines use a solenoid to cut off fuel when you turn the key off. The computer sees a problem with that solenoid or its wiring.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the fuse and relay for the shutoff solenoid
  2. Listen for the solenoid clicking when the key is turned on
  3. Inspect the solenoid connector and wiring

Signs you may notice

  • Engine won't start, or won't shut off with the key
  • Engine stalls or cuts out while driving
  • Check engine light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty fuel shutoff solenoid
  • CommonDamaged wiring or corroded connector
  • PossibleBlown fuse or bad relay
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a new shutoff solenoid or a wiring repair.

Walk through it step by step: Car won't start →

Common questions

What does P0215 mean?

Many diesel engines use a solenoid to cut off fuel when you turn the key off. The computer sees a problem with that solenoid or its wiring.

Can I drive with code P0215?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0215?

Common possibilities to test include: faulty fuel shutoff solenoid; damaged wiring or corroded connector; blown fuse or bad relay; engine computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.