Home › Code lookup › P0216
Powertrain code · Fuel and air

P0216 Injector/Injection Timing Control Circuit

How urgent? Get it checked in the next few days

What it means

On diesel engines the computer controls exactly when fuel is injected. It sees a problem in the circuit that controls that timing.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check fuel supply pressure and the fuel filter first
  2. Inspect the injection pump wiring and connectors
  3. Check timing data on a scan tool while the engine runs

Signs you may notice

  • Hard starting
  • Rough running, stalling or loss of power
  • Extra smoke from the exhaust
  • Check engine light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailing injection pump or its electronic driver
  • CommonDamaged wiring or corroded connector at the pump
  • PossibleLow fuel supply from a weak lift pump or clogged filter
  • PossibleFaulty injection timing sensor
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Often a fuel supply repair or a new injection pump driver or pump. Confirm fuel supply is good before replacing the pump.

Where it shows up

  • Well known on GM 6.5L diesels with a failing pump-mounted fuel solenoid driver
  • Also seen on Dodge Ram Cummins trucks with the VP44 injection pump
Walk through it step by step: Car has no power when accelerating →

Common questions

What does P0216 mean?

On diesel engines the computer controls exactly when fuel is injected. It sees a problem in the circuit that controls that timing.

Can I drive with code P0216?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0216?

Common possibilities to test include: failing injection pump or its electronic driver; damaged wiring or corroded connector at the pump; low fuel supply from a weak lift pump or clogged filter; faulty injection timing sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.