Home › Code lookup › P0220
Powertrain code · Fuel and air

P0220 Throttle/Pedal Position Sensor/Switch "B" Circuit

How urgent? Get it checked in the next few days

What it means

Your car uses two or more sensors to report gas pedal or throttle position. The computer sees a problem with the signal from sensor B.

Can I keep driving?

Not safely in traffic if the engine is stuck near idle or won't respond to the gas pedal; you may not be able to merge or get out of the way. Pull over and have it towed if that happens. If it seems to drive normally, keep trips short, avoid highways and get it checked soon.

What to test before replacing parts

Check the throttle body and pedal connectors, 5-volt reference and ground, and compare both sensor signals as the throttle moves before replacing the throttle body or pedal assembly.

  1. Inspect the connectors at the throttle body and gas pedal for corrosion or loose pins
  2. With a scan tool, compare sensor readings while slowly pressing the pedal
  3. Check the sensor's 5-volt reference and ground at the connector

Signs you may notice

  • Check engine light on, often with a reduced power warning
  • Engine stuck near idle or in limp mode
  • Poor or no response to the gas pedal
  • Rough idle or stalling

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty electronic throttle body (sensor is built in)
  • CommonFaulty gas pedal position sensor
  • CommonLoose or corroded connector at the throttle body or pedal
  • PossibleDamaged wiring between the sensor and computer
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a new throttle body or gas pedal assembly, depending on which part holds the faulty sensor. Fix any wiring or connector damage first.

Repair costInsufficient verified pricing for this vehicle and repair
Replace electronic throttle body. Prepare an itemized shop request.
Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P0220 mean?

Your car uses two or more sensors to report gas pedal or throttle position. The computer sees a problem with the signal from sensor B.

Can I drive with code P0220?

Not safely in traffic if the engine is stuck near idle or won't respond to the gas pedal; you may not be able to merge or get out of the way. Pull over and have it towed if that happens. If it seems to drive normally, keep trips short, avoid highways and get it checked soon.

What causes P0220?

Common possibilities to test include: faulty electronic throttle body (sensor is built in); faulty gas pedal position sensor; loose or corroded connector at the throttle body or pedal; damaged wiring between the sensor and computer. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.