Home › Code lookup › P0224
Powertrain code · Fuel and air

P0224 Throttle/Pedal Position Sensor/Switch "B" Circuit Intermittent

How urgent? Get it checked in the next few days

What it means

Your car uses two or more sensors to report gas pedal or throttle position. Sensor B's signal keeps cutting in and out.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the connectors at the throttle body and gas pedal for corrosion or loose pins
  2. Watch the sensor readings on a scan tool while wiggling the harness
  3. Check the sensor's 5-volt reference and ground at the connector

Signs you may notice

  • Check engine light on, often with a reduced power warning
  • Engine stuck near idle or in limp mode
  • Poor or no response to the gas pedal
  • Rough idle or stalling

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLoose or corroded connector at the throttle body or pedal
  • CommonChafed wiring that loses contact over bumps
  • CommonFaulty electronic throttle body (sensor is built in)
  • CommonFaulty gas pedal position sensor

Typical repair once the cause is confirmed

Usually a new throttle body or gas pedal assembly, depending on which part holds the faulty sensor. Fix any wiring or connector damage first.

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P0224 mean?

Your car uses two or more sensors to report gas pedal or throttle position. Sensor B's signal keeps cutting in and out.

Can I drive with code P0224?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0224?

Common possibilities to test include: loose or corroded connector at the throttle body or pedal; chafed wiring that loses contact over bumps; faulty electronic throttle body (sensor is built in); faulty gas pedal position sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.