P0225 Throttle/Pedal Position Sensor/Switch "C" Circuit
What it means
Your car uses two or more sensors to report gas pedal or throttle position. The computer sees a problem with the signal from sensor C.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the connectors at the throttle body and gas pedal for corrosion or loose pins
- With a scan tool, compare sensor readings while slowly pressing the pedal
- Check the sensor's 5-volt reference and ground at the connector
Signs you may notice
- Check engine light on, often with a reduced power warning
- Engine stuck near idle or in limp mode
- Poor or no response to the gas pedal
- Rough idle or stalling
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty electronic throttle body (sensor is built in)
- CommonFaulty gas pedal position sensor
- CommonLoose or corroded connector at the throttle body or pedal
- PossibleDamaged wiring between the sensor and computer
- PossibleEngine computer fault
Typical repair once the cause is confirmed
Usually a new throttle body or gas pedal assembly, depending on which part holds the faulty sensor. Fix any wiring or connector damage first.
Common questions
What does P0225 mean?
Your car uses two or more sensors to report gas pedal or throttle position. The computer sees a problem with the signal from sensor C.
Can I drive with code P0225?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0225?
Common possibilities to test include: faulty electronic throttle body (sensor is built in); faulty gas pedal position sensor; loose or corroded connector at the throttle body or pedal; damaged wiring between the sensor and computer. A shop should confirm the cause before replacing parts.