Home › Code lookup › P0228
Powertrain code · Fuel and air

P0228 Throttle/Pedal Position Sensor/Switch "C" Circuit High

How urgent? Get it checked in the next few days

What it means

Your car uses two or more sensors to report gas pedal or throttle position. Sensor C's signal voltage is higher than it should ever be.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the connectors at the throttle body and gas pedal for corrosion or loose pins
  2. Check the sensor's 5-volt reference and ground at the connector

Signs you may notice

  • Check engine light on, often with a reduced power warning
  • Engine stuck near idle or in limp mode
  • Poor or no response to the gas pedal

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty electronic throttle body (sensor is built in)
  • CommonFaulty gas pedal position sensor
  • CommonOpen ground wire or signal wire shorted to voltage
  • CommonLoose or corroded connector at the throttle body or pedal
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a new throttle body or gas pedal assembly, depending on which part holds the faulty sensor. Fix any wiring or connector damage first.

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P0228 mean?

Your car uses two or more sensors to report gas pedal or throttle position. Sensor C's signal voltage is higher than it should ever be.

Can I drive with code P0228?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0228?

Common possibilities to test include: faulty electronic throttle body (sensor is built in); faulty gas pedal position sensor; open ground wire or signal wire shorted to voltage; loose or corroded connector at the throttle body or pedal. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.