Home › Code lookup › P022C
Powertrain code · Fuel and air

P022C Charge Air Cooler Bypass Control "A" Circuit High

How urgent? Book a check when convenient

What it means

Some turbo engines, mostly diesels, have a valve that can route intake air around the intercooler, for example to warm up faster. The control circuit for bypass valve A reads higher than expected, often from a short to power.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the bypass valve connector and wiring
  2. Check the actuator's resistance and the computer's control signal

Signs you may notice

  • Check engine light on
  • Often no noticeable change in how it drives
  • Possibly reduced power or slower warm-up

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty bypass valve actuator
  • CommonDamaged wiring or corroded connector
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a wiring or connector repair, or a new bypass valve actuator.

Common questions

What does P022C mean?

Some turbo engines, mostly diesels, have a valve that can route intake air around the intercooler, for example to warm up faster. The control circuit for bypass valve A reads higher than expected, often from a short to power.

Can I drive with code P022C?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P022C?

Common possibilities to test include: faulty bypass valve actuator; damaged wiring or corroded connector; engine computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.