Home › Code lookup › P0230
Powertrain code · Fuel and air

P0230 Fuel Pump Primary Circuit

How urgent? Get it checked in the next few days

What it means

The computer switches the fuel pump on through a relay or driver module. It sees a problem in the circuit that does the switching.

Can I keep driving?

If the engine stalls or sputters, don't keep driving; the fuel pump could cut out in traffic and leave you stranded with heavy steering and brakes. If it starts and runs normally, keep trips short and go straight to a shop soon.

What to test before replacing parts

Check the fuel pump fuse, relay and inertia switch, listen for pump hum, and test power at the pump and the relay control wiring before replacing the pump, driver module or computer.

  1. Listen for the fuel pump to hum for a couple of seconds with the key on
  2. Check the fuel pump fuse and swap in a known-good relay
  3. Inspect the relay control wiring, and the inertia switch if the vehicle has one

Signs you may notice

  • Engine cranks but won't start
  • Stalling while driving
  • No fuel pump hum when the key is turned on
  • Check engine light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty fuel pump relay
  • CommonBlown fuel pump fuse
  • CommonDamaged wiring or corroded connector in the relay control circuit
  • PossibleFaulty fuel pump driver module
  • PossibleTripped fuel shutoff (inertia) switch on some Ford vehicles
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a new fuel pump relay or fuse, or a wiring repair. A driver module or computer fault is less common.

Repair costInsufficient verified pricing for this vehicle and repair
Replace fuel pump relay and repair control circuit. Prepare an itemized shop request.
Walk through it step by step: Car won't start →

Common questions

What does P0230 mean?

The computer switches the fuel pump on through a relay or driver module. It sees a problem in the circuit that does the switching.

Can I drive with code P0230?

If the engine stalls or sputters, don't keep driving; the fuel pump could cut out in traffic and leave you stranded with heavy steering and brakes. If it starts and runs normally, keep trips short and go straight to a shop soon.

What causes P0230?

Common possibilities to test include: faulty fuel pump relay; blown fuel pump fuse; damaged wiring or corroded connector in the relay control circuit; faulty fuel pump driver module. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.