Home › Code lookup › P0232
Powertrain code · Fuel and air

P0232 Fuel Pump Secondary Circuit High

How urgent? Get it checked in the next few days

What it means

The computer watches the power that goes out to the fuel pump. Here the voltage on the output side is higher than expected.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Listen for the fuel pump to hum for a couple of seconds when the key is turned on
  2. Inspect the fuel pump connector (often on top of the tank) and its wiring
  3. Check fuel pump voltage and ground at the pump

Signs you may notice

  • Engine may crank but not start
  • Stalling or sputtering while driving
  • Check engine light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFuel pump wire shorted to power
  • CommonFuel pump relay stuck on
  • PossibleFuel pump unplugged or open circuit to the pump
  • PossibleFaulty fuel pump driver module or computer

Typical repair once the cause is confirmed

Usually a wiring or connector repair at the tank, or a new fuel pump if it is worn out.

Walk through it step by step: Car won't start →

Common questions

What does P0232 mean?

The computer watches the power that goes out to the fuel pump. Here the voltage on the output side is higher than expected.

Can I drive with code P0232?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0232?

Common possibilities to test include: fuel pump wire shorted to power; fuel pump relay stuck on; fuel pump unplugged or open circuit to the pump; faulty fuel pump driver module or computer. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.