Home › Code lookup › P0234
Powertrain code · Fuel and air

P0234 Turbocharger/Supercharger "A" Overboost Condition

How urgent? Get it checked in the next few days

What it means

The turbo or supercharger made more boost pressure than the computer asked for. The computer usually cuts power to protect the engine.

Can I keep driving?

Ease off and avoid hard acceleration. Too much boost can damage the engine, and the car may suddenly cut power. If you hear knocking or pinging, see smoke or lose power at speed, pull over safely and have it towed. Otherwise drive gently to a shop soon.

What to test before replacing parts

Check wastegate movement, the boost control solenoid and vacuum hoses, and compare the boost sensor with barometric pressure. Ask about any aftermarket tune before blaming the turbo.

  1. Inspect boost control vacuum hoses and the wastegate linkage
  2. Compare the boost sensor reading with barometric pressure with the engine off
  3. Command the boost control solenoid and wastegate with a scan tool and watch them move

Signs you may notice

  • Check engine light on, often with limp mode
  • Sudden loss of power while accelerating
  • A surge of power just before the power cut
  • Possible engine knock or pinging

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWastegate or wastegate actuator stuck closed
  • CommonFaulty boost control solenoid or cracked vacuum hoses
  • CommonSticking variable-vane turbo (mostly diesels)
  • PossibleFaulty boost pressure sensor reading too high
  • PossibleAftermarket tune or boost controller

Typical repair once the cause is confirmed

Usually a new wastegate actuator or boost control solenoid, or freeing a sticking wastegate or turbo vanes. Replace the turbo only if it's confirmed stuck.

Repair costInsufficient verified pricing for this vehicle and repair
Replace wastegate actuator or boost control solenoid. Prepare an itemized shop request.

Where it shows up

  • Often seen on small turbo gas engines such as the GM 1.4L turbo in the Cruze, Trax and Encore

Known on these vehicles

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P0234 mean?

The turbo or supercharger made more boost pressure than the computer asked for. The computer usually cuts power to protect the engine.

Can I drive with code P0234?

Ease off and avoid hard acceleration. Too much boost can damage the engine, and the car may suddenly cut power. If you hear knocking or pinging, see smoke or lose power at speed, pull over safely and have it towed. Otherwise drive gently to a shop soon.

What causes P0234?

Common possibilities to test include: wastegate or wastegate actuator stuck closed; faulty boost control solenoid or cracked vacuum hoses; sticking variable-vane turbo (mostly diesels); faulty boost pressure sensor reading too high. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.